HOW TO PROGRAM DISH TV REMOTE TV CODES

• TO PROGRAM IF CODE IS KNOWN
• Write down the setup codes for your TV, to synchronise it with Dish TV.

1. Press the TV button on the remote control, and Hold it down, until [SAT - VCR and AUX] buttons on it light up.Now release the TV button.  The lighted up buttons will start flashing.
2. Enter the code using keypad.  If you want to remote to control all functions on the TV, enter the code and press the [#] button.  The TV button will flash three times. 
3. Press the Power button to turn OFF the TV, and turn it back ON again.  If the codes were correct, the TV will turn OFF and ON.  If the TV does not power down or back ON, try next code from the listTO PROGRAM WITHOUT CODE

1. Press the TV button on the remote control, and hold it down until, SAT, VCR & AUX  buttons 
2. lights up.  
3. Release the TV button, and they will be flashing.
4. Press and release the 'Power" button on the remote control.
5. Press the "Arrow Up" key and stop.  If the TV do not turns OFF, press the "Arrow Up" key again.  Continue pressing 'Arrow Up" key, until TV turns OFF.  Do not go fast.  You could miss the correct code.  Wait at least 20 seconds between each press, to see if the code works, before an other press 
6. Press [#] key on the remote control, when the TV turns OFF, to lock in the code