Friday, 8 February 2019

ONE FOR ALL URC 3050 _ SETUP PROCEDURE

ONE FOR ALL URC 3050 _ SETUP PROCEDURE




  1. Turn on your TV, VCR or Cable Box, depending on the device you are programming.
  2. Press TV* and release. Press and hold SETUP until the One For All® So Easy 3 Device's red light blinks twice. Release SETUP.

Note: When setting up your VCR and/or Cable Box, substitute the appropriate device key (VCR or CBL).

TV SETUP
  • Aim the One For All® So Easy3 Device at your TV and press POWER. Your TV should turn off.
  • If it doesn't, repeat Steps 2-4, trying each code listed for your brand until you find the one that operates your TV.
VCR SETUP
  • Aim the One For All® So Easy3 Device at your VCR and press POWER. Your VCR should turn off.
  •  If it doesn't, repeat Steps 2-4, trying each code listed for your brand until you find the one that operates your VCR.
  • If your original VCR remote did not have a POWER key, put a tape in your VCR and press PLAY on the One For All® So Easy3 Device.
CABLE SETUP
  • Aim the One For All® So Easy 3 Device at your Cable Box and press POWER.
  • Your Cable Box should turn off.
  • If it doesn't, repeat Steps 2-4, trying each code listed for your brand until you find the one that operates your Cable Box.
  • If your original Cable Box remote did not have a "ON" key, Use CH + on the One For All® So Easy 3 Device to turn your Cable Box on.
If you cannot get the One For All® So Easy 3 Device to operate your equipment or perform commands properly:

  • Try all of the codes listed for your TV, VCR or Cable Box in the Set-Up Codes.
  • Many set-up codes may allow partial functionality, however, only one code will operate your device correctly.
  • Make sure you are within 15 feet of your equipment when using your remote control.
  • If the red light on the remote control does not blink when you press a key, replace the batteries with two (2) new AAA alkaline batteries.

Be sure you match the batteries to the plus (+) and minus (-) marks inside the battery case.

  • No volume when in the Cable mode or when operating a second TV or TV/VCR combination?

Press and hold SETUP until the red light blinks twice, then release SETUP. Press CH- /+ CH- /+ VOL- then press VOL+.
at