JBL BPX2200.1 - 2-CHANNEL POWER AMPLIFIER (CAR) - WIRING DIAGRAM and CIRCUIT DIAGRAM
SCHEMATIC & WIRING DIAGRAM_JBL BPX2200.1-CAR-POWER AMPLIFIER_2-CHANNEL
Power output – 2 Ohms > 1100W
x 2
Power output (bridged)-4Ohms >
2200W x 1
Power output (parallel) – 1 Ohms
> 2200 x 1
Minimum speaker impedance > 1
Ohm
Frequency response > 20Hz to
320KHz – 3dB
Input sensitivity (RCA Type) >
250mV – 6V
THD + Noise {4 Ohms} > 0.5%
Signal to Noise ratio > 93dB
Maximum current draw > 190A
Fuse replacement > 150A x 1
All tests to be done, unless otherwise specified, from 10Hz to 320Hz
at 14.4V DC into 2 ohm loads and adjust the units gain so that with a
.775 volt input signal the unit is at its maximum rated output. All
measurements will be done using an Audio precision system one and the
supply voltage. An A+ line voltage of 14.4V DC shall be applied to the
unit under test for all measurements unless otherwise specified. The
voltage applied to the unit shall be measured at the power connection on
the Amplifier.
Signal Source
Unless otherwise specified, all tests shall be conducted with the
Audio Signal Generator output configured to be balanced, less than or
equal to 50 ohm source impedance, and floating. The signal source "GND"
shall be connected to the Amplifier PWR GND at the Amplifier.
Output Load
Unless otherwise specified, all tests shall be conducted with 2 ohm
resistive loads having less than 10% reactive components at any
frequency below 350Hz. Each resistor shall have a value that remains
within 1% while dissipating the rated output of the unit under test.
Power Indicator LED steadily illuminates for normal operation. LED
blinks when protection circuitry is engaged, and during power up.
SCHEMATIC DIAGRAM
WIRING DIAGRAM
APPLICATIONS – BPx MODELS
To the right are several application diagrams to help plan your
subwoofer system installation. Figures 1 through 3 show how to configure
the JBL Power Series subwoofer amplifiers (models BPx500.1, BPx1100.1
and BPx2200.1) for 2-channel, bridged-mono and parallel-mono operation “Setting the Output Mode” )
NOTE: For simplicity, Figures 1 through 3 do not show power, remote and input connections.
NOTE: If the nominal impedance of your speaker system is close to 2
ohms, be prepared to try both bridged and parallel configurations to
determine which performs better.
CLICK ON THE PICTURES TO ZOOM IN