SAMSUNG UE32C4000P - LED TV - HOW TO UPGRADE SUB-MICOM WITH DDC MANAGER – USB DOWNLOAD METHOD

SAMSUNG UE32C4000P - LED TV - HOW TO UPGRADE SUB-MICOM WITH DDC MANAGER – USB DOWNLOAD METHOD

How to UPGRADE SUB-MICOM WITH DDC MANAGER – USB DOWNLOAD METHOD

SAMSUNG  UE32C5*** - UE37C5*** - UE40C5*** - UE46C5*** - UE32C4000P* - LED TV

USB UPGRADE PROCEDURE

Samsung may offer upgrades for TV’s firmware in the future. Please contact the Samsung call center to receive information about downloading upgrades and using a USB drive. Upgrades will be possible by connecting a USB drive to the USB port located on your TV.

> Insert a USB drive containing the firmware (T-TDT5DEUC) upgrade into the USB port on the rear of the TV.
> Press the MENU button to display the menu.  Press the or button to select "Support", then press the ENTER button.
> Press the or button to select "SW Upgrade", then press the ENTER button.  The message "Scanning for USB. It may take up to 30 seconds." is displayed.
> The message "Upgrade version XXXX to version XXXX?  The system will be reset after upgrade." is displayed.
> Press the or to select the "OK", then press the ENTER button.

Be careful to not disconnect the power or remove the USB drive while upgrades are being applied. The TV will turn off and turn on automatically after completing the firmware upgrade.  Check the firmware version after the upgrades are complete. When software is upgraded, video and audio settings you have made will return to their default (factory) settings.
Write down your settings so that you can easily reset them after the upgrade. (Recommended)

HOW TO UPGRADE THE SUB-MICOM WITH DDC MANAGER

* Connect DDC MANAGER to the TV Set with D-SUB cable. And Power on.  (USB type : MTI-2510 / parallel type : MTI-2059)

* Enter the factory mode.  Control - EDID - EDID ON/OFF Select ON.

* Open the DDC tool. (Parallel type & USB type)

* Load the sub micom program fie (T-TDT5DEUS-XXXX.BIN).

* Push the ‘Program’ Button.  (It takes quite a bit of time. You can wait or close the DDC tool by force and open tool and load fie again.)

* Push the ‘Program’ Button again. (It takes about 100 seconds.)

If update completes, TV set will booting automatically. Disconnect the JIG.

> To enter the factory mode; press the remote control keys in this sequence [Power OFF > Info > Menu > Mute > Power On.]

If you want to enter the hidden factory mode.

# Enter into the factory mode first.

# Move the tap to Advanced

# Key in “0 + 0 + 0 + 0.  The hidden menu: Advanced will be displayed. Never enter factory mode and adjust the data values there, if you are not familiar with.  You should know, what you are going to do, and what will be the result.  Improper adjustments to data values here might make the set even in-operative; and irresponsive to any signal thereafter.