SHARP LC-37DW99U - ADJUSTMENTS AFTER REPLACING LCD CONTROL PCB - LCD MODULE ASSEMBLY & PARTS CODES
When replacing the LCD
control PCB, follow these steps to adjust VCOM.
- Enter the adjustment process mode.
- Select the item [VCOM ADJ] on the page 3/26 using the CH ▼/▲ keys on the remote controller.
- Press the Enter key to check that the adjustment pattern is displayed.
- Adjust the flicker in the middle of the screen to minimum using the VOL (+)/(-) keys on the remote controller.
- Press the Enter key to turn off the pattern.
- To exit the adjustment process mode after the adjustment is done, unplug the AC cord from the outlet to make a forced shutdown. (When the power was turned off with the remote controller, once unplug the AC cord and plug it again. In this case, wait 10 seconds or so before plugging.)
CAUTION: Use due care in
handling the information described here lest your users should know how to
enter the adjustment process mode. If the settings are tampered
in this mode, unrecoverable system damage may result.
DESCRIPTION OF DISPLAY
LCD MODULE ASSEMBLY
Click on pictures to Enlarge
PARTS CODE
