MCC-1 - INFINITY - Sub Amplifier: Sub 100 - SERVICE HELP
Modulus Home Cinema System: Sub Amplifier: Sub 100 _ INFINITY - Repair Help
MCC-1_CENTRE DISASSEMBLE
* Remove the grille.
* Remove the (7) exposed rubber
grille retainers; this can be accomplished by carefully pulling them out of
their cavities with long-nosed pliers or similar tool.
* Remove the (7) Phillips screws
that are now exposed.
* Four additional screws lie
underneath the two front trim panels; these can be carefully removed by
applying a blow dryer (high or maximum) or heat gun to the trim panels. Take
care not to direct the gun directly at the woofer or tweeter; do not burn
yourself after each panel has been heated –gloves are recommended. See
illustration. If either trim panel is damaged upon removal, order: part#
MODCTRPLATE-L–Left Trim Panel: part# MODCTRPLATE-R –Right Trim Panel.
* Remove the (4) additional
Phillips screws that are now exposed.
* Carefully lift the front
baffle, with drivers attached, off the cabinet.
Reassembly: Adhesive already
in place, if encrusted on the front baffle, must be removed by scraping it off
as it may prevent the trim panel from sitting flush on the front baffle. New
adhesive must be added to reattach the trim panel.
MODULUS
MS-1 SATELLITE
* Remove the grille.
* Remove the (4) exposed rubber
grille retainers; this can be accomplished by carefully pulling them out of
their cavities with long-nosed pliers or similar tool.
* Remove the (4) Phillips screws
that are now exposed.
* Two additional screws lie
underneath the front trim panel; this can be carefully removed by applying a
blow dryer (high or maximum) or heat gun to the trim panel. Take care not to
direct the gun directly at the woofer or tweeter; do not burn yourself after
the panel has been heated –gloves are recommended. See illustration. If this
trim panel is damaged upon removal, order: part# MODSATDECCHAR (Charcoal): part#
MODSATDECPLAT (Platinum)
* Remove the (2) additional
Phillips screws that are now exposed.
* Carefully lift the front
baffle, with drivers attached, off the cabinet.
Reassembly: Adhesive already
in place, if encrusted on the front baffle, must be removed by scraping it off
as it may prevent the trim panel from sitting flush on the front baffle. New
adhesive must be added to reattach the trim panel.
SCHEMATICS
