Tuesday, 28 April 2020

REPAIR / SERVICING TV MYSTERY MTV-1608W

Technical description and composition of the MYSTERY MTV-1608W TV, type of panel and applicable modules. The composition of the modules.
MYSTERY
Model: MTV-1608W
Chassis / Version: GH-TS26KU-S1
Panel: LTN156AT02
Power Supply (PSU): Power
PWM Power: IC_Power
MainBoard: GH-TS26KU-S1 (20100127 REV 1.0 PROJECT 3600E001R)
IC MainBoard: CPU: TSUMV36KE-LF, Spi Flash: 25F40, MC4558CDT, 74HC4052D, FT24C32A, CT3257A, FP6180, TDA1517P
Tuner: TNF931D-BFDR1B
Technical Specifications MTV-1608W
MYSTERY MTV-1608W
General recommendations for repairing TV LCD
Possible manifestations of defects
- The MYSTERY MTV-1608W TV does not turn on and does not show any signs of operability at all. There is no reaction to the remote control and control buttons from the front panel.
Often in such cases, the Power module is faulty. It is necessary to measure the output voltages in its secondary circuits, and if they are completely absent, it is necessary to check the serviceability of power switches and rectifier diodes for possible breakdown (short circuit).
In case of diode breakdowns in the secondary circuits, the converter can operate in emergency short-circuit mode without output voltages, and during short circuit in the power elements of the primary circuit, the mains fuse and / or current sensor at the source of the key usually breaks.
Mos-Fet power switches, used in switching power supplies, sometimes fail due to a malfunction of any other elements that can put it out of operation in key mode or create an excess of the maximum permissible parameters of the switch. These can be elements supplying the PWM controller, frequency-setting or damping circuits, or negative feedback elements in the stabilization circuit. IC_Power PWM controllers, in the absence of visible damage or open faults between the terminals, are checked by replacing them with new ones, or obviously working ones.
- There is no image, there is sound, it responds to the remote control, the channels are switched. In some cases, the image appears when you turn on and immediately disappears.
The defect can be caused by problems in the nodes or elements of the backlight of the display, or in the power supply of the lamps or inverter. If all the electrolytic capacitors of the filter according to the power supply of the inverter are working, make sure that the lamps are working, then you need to check the converter keys and the secondary windings of the transformers.
If in diagnosing a malfunction, it is necessary to disable the inverter protection, there is a risk of failure of the power elements of the inverter, and special care is required during work, and after they are finished, it is necessary to restore the protection circuits for further safe operation of the TV by the owner in normal mode.
- The indicator on the front panel blinks, the TV does not turn on in the operating mode, it does not respond to the remote control.
Repair or diagnostics of the GH-TS26KU-S1 motherboard should begin by checking the stabilizers and power converters needed to power the chips and matrix. If necessary, update or replace the software (software). Complex repair of MB (SSB) is possible only in the conditions of a service center with the necessary equipment. Checking or replacing CPU elements: TSUMV36KE-LF, Spi Flash: 25F40, MC4558CDT, 74HC4052D, FT24C32A, CT3257A, FP6180, TDA1517P requires the necessary training and professional skills to repair modules at the component level. Problems associated with the use of BGA soldering technologies can sometimes be diagnosed by warming up.
If the TV works normally from external devices, but does not tune into television channels, the TNF931D-BFDR1B tuner may be malfunctioning. In such cases, first of all, you should make sure that there are supply voltages at its corresponding conclusions. You also need to make sure that the tuner and processor can exchange data via the I2C bus. Sometimes the cause of the inoperability of the tuner may be a software failure.
TV users and owners need to remember that attempts to self-repair a MYSTERY MTV-1608W TV without the appropriate qualifications and necessary experience can lead to serious negative consequences!


SCHEMATIC DIAGRAM  / SERVICE MANUAL   ------------------>    MYSTERY MTV-1608W Chassis GH-TS26KU-S1

 The appearance of the MainBoard MS63083-ZC01-01 is shown in the figure below:
MS63083-ZC01-01
MS63083-ZC01-01 can be used in TVs:
MYSTERY MTV-3229LTA2 (Panel V320BJ7-PE1), MYSTERY MTV-2429LTA2 (Panel V236BJ1-P01), MYSTERY MTV-3030LTA2 (Panel V290BJ1-PE1).
Main features of the MYSTERY MTV-1608W device:
Installed matrix (LCD panel) LTN156AT02.
The necessary supply voltages for all nodes of the MYSTERY MTV-1608W TV are generated by the Power supply module, or its analogs using IC_Power microcircuits.
MainBoard - the main board (motherboard) is a GH-TS26KU-S1 module using CPU chips: TSUMV36KE-LF, Spi Flash: 25F40, MC4558CDT, 74HC4052D, FT24C32A, CT3257A, FP6180, TDA1517P and others.
The TNF931D-BFDR1B tuner provides television reception and channel tuning.
Additional technical information about the panel:
Brand: SAMSUNG
Model: LTN156AT02-W04
Type: a-Si TFT-LCD, Panel
Diagonal size: 15.6 inch
Resolution: 1366x768, WXGA
Active Area: 344.232x193.536 mm
Shape Style: Wedge (PCBA Bent, Depth? 5.2mm)
Display Colors: 262K (6-bit)
Frequency: 60Hz
Lamp Type: WLED
Signal Interface: LVDS (1 ch, 6-bit)
The MYSTERY MTV-1608W TV with an LTN156AT02 LCD display, a diagonal size of 16 "(41 cm) in a 16: 9 format. The brightness of the screen is 220 cd / m² with CCFL (EEFL) fluorescent lamps. Contrast, as the ratio of maximum brightness to minimum, is 600: 1. It is possible to view images in high quality HD at a resolution of 1366x768 pixels in the standard for graphic decomposition 720p (HD Ready). The input high-frequency or video signal can be processed in analog systems PAL, SECAM, NTSC. Graphic processing and digital signal generation takes place in one hundred Standard 480i, 480p, 576i, 576p, 720p, 1080i, 1080p.
The power of the acoustic system of sound 6 W (2x3 W) provide two speakers. The audio processing system NICAM STEREO is used.
The external interface (communication with other devices) is supported by standard input and output connectors: antenna input (RF), AV, audio x2, S-Video, component, SCART, RGB, VGA, HDMI. An output for connecting headphones is provided. To connect a computer or laptop to this TV model, a VGA (D-Sub 15) connector is used on the TV case, this interface supports resolutions: 640x480, 800x600, 1024x768, 1360x768.
The power consumed by the TV in the operating mode from the network is 40 watts.
Dimensions: With stand 642x444x209 mm, Without stand 570x345x70 mm.
Attention! The MYSTERY MTV-1608W LCD TV panel LTN156AT02 is its most expensive component.
Avoid hitting the glass and exerting pressure on the screen to avoid permanent damage to the LCD panel!