Technical description and composition of the SUPRA STV-LC40ST1000F TV, panel type and modules used. The composition of the modules.SUPRA LED
Model: STV-LC40ST1000F
Chassis / Version: V1S11
Panel: V400HJ6-PE1 C3
LED driver (backlight): integrated into MainBoard
PWM LED driver: OZ9902DGN
Power Supply (PSU): integrated into MainBoard
PWM Power: FA8A01
MOSFET Power: TO-252
MainBoard: 5800-A7N02G-0P00 VER 00.02
IC MainBoard: SPI Flash: MX25L1606E,
Tuner: NoName
STV-LC40ST1000F Specifications
SUPRA STV-LC40ST1000F
General recommendations for TV LCD LED repair
Possible malfunctions
- SUPRA STV-LC40ST1000F TV does not turn on and does not show any signs of operation at all. No response to the remote control and front panel control buttons.
In this case, the main power supply, the AC / DC voltage converter, may be faulty, the elements of which in this model are located on the main board MainBoard 5800-A7N02G-0P00. Its output voltages should be measured, and if they are absent, check the serviceability of the power switches (TO-252) of the converters and rectifier diodes for the probability of a short circuit.
In case of breakdowns in the secondary circuits of the converter, it can usually work in an emergency mode in a short circuit, and with a short circuit in the power elements of the primary circuit, the mains fuse or current sensor in the source of the key is most often cut off.
Mos-Fet power switches used in switching power supplies sometimes fail due to a malfunction of any other elements that can disable it in the key mode, or create an excess of the maximum permissible key parameters. These can be elements supplying a PWM regulator, frequency setting or damper circuits, or elements of negative feedback in the stabilization circuit. PWM controllers FA8A01, in the absence of visible damage or outright short circuits between the terminals, are checked by replacing them with new ones, or known to be working properly.
- No picture, sound, all other TV functions work. When turned on, the image may sometimes appear for a second.
As a rule, in this case, the backlight of the LED panel is faulty. Most often the reason for this is a break in the LEDs, or poor contact in the connectors of the brackets, less often the LED driver may be faulty.
To identify an open circuit in the LED lines without disassembling the panel, a current source is required. It is impossible to open the junctions connected in series with a simple multimeter; a voltage of several tens of volts is required.
- The indicator on the front panel blinks, the TV does not turn on in operating mode, does not respond to the remote control.
Repair or diagnostics of the 5800-A7N02G-0P00 motherboard should begin with checking the stabilizers and power converters required to power the microcircuits and matrix. If necessary, you should update or replace the software (software). If it is not possible to replace the MB (SSB) board, it is necessary to check the serviceability of its elements, for example, SPI Flash MX25L1606E. Defective components must be replaced.
If you suspect a malfunction of the NoName tuner, first of all, you need to make sure that the software is correct, as well as the presence of the necessary levels of supply voltages and pulses of data exchange with the processor via the I2C bus on the corresponding terminals of the tuner.
Attention to TV owners! Attempts to repair SUPRA STV-LC40ST1000F on your own are not recommended by the manufacturer and can lead to serious negative consequences!
DOWNLOAD FIRMWARE FOR SPI FLASH -----------> SUPRA STV-LC40ST1000F V1S11, Main: 5800-A7N02G-0P00 VER 00.02, Panel: V400HJ6-PE1 C3
MainBoard 5800-A7N02G-0P00 is shown in the figure below:5800-A7N02G-0P00
Main features of SUPRA STV-LC40ST1000F device:
Installed matrix (LED panel) V400HJ6-PE1 C3.
To power the backlight LEDs, a converter combined with the 5800-A7N02G-0P00 main board is used, controlled by the OZ9902DGN PWM controller.
The power module is combined with the MainBoard and is made according to the AC / DC flyback voltage converter using FA8A01 microcircuits and TO-252 power switches.
MainBoard - the main board (motherboard) is a 5800-A7N02G-0P00 module, using SPI Flash chips: MX25L1606E, and others.
Tuner NoName provides reception of television programs and tuning to channels.
Additional technical information about the panel:
Brand: INNOLUX
Model: V400HJ6-PE1 Rev.C2
Type: a-Si TFT-LCD, CELL
Diagonal size: 40 inch
Resolution: 1920x1080, FHD
Display Mode: MVA, Normally Black, Transmissive
Active Area: 878.112x485.352 mm
Surface: Antiglare (Haze 1%)
Glass Depth: 0.50 + 0.50 mm
Transmissivity: 6.0% (with Polarizer)
Contrast Ratio: 5000: 1
Display Colors: 16.7M (8-bit)
Response Time: 8.5 (G to G)
Frequency: 60Hz
Signal Interface: LVDS (2 ch, 8-bit), 51 pins
Voltage: 12.0V
SUPRA LED TV STV-LC40ST1000F with LCD V400HJ6-PE1, diagonal 40 "(102 cm) in 16: 9 format. The required screen brightness of 260 cd / m² is provided by LED backlighting. Dynamic contrast ratio of 120,000: 1 is achieved by special control operation of LEDs depending on the illumination of areas in the scene.The display technology of the model uses LED LED backlighting.Capabilities of the TV provide viewing of broadcasts and films in high quality HD at a resolution of 1920x1080 pixels in graphic resolution according to the standard 1080p (Full HD).
STV-LC40ST1000F has built-in SMART software and pre-installed Android Operating System. Internet connection can be made via Wi-Fi wireless connection. Supported media file formats: MP3, WMA, MPEG4, MKV, JPEG.
Speaker power 12 W (2x6 W) is provided by two speakers. Uses NICAM stereo signal processing system and Sound Surround function.
External interface (communication with other devices) is supported by standard input and output connectors: antenna input (RF), AV, HDMI x2, MHL, USB x2, Ethernet (RJ-45), Wi-Fi, Miracast. A headphone output is provided. The digital tuner is capable of receiving TV channels in the DVB-T MPEG4, DVB-C, DVB-T2, DVB-S2 standards.
Dimensions: with stand 907x571x219 mm, without stand 907x521x85 mm.
TV weight: with stand: 7 kg, without stand: 6.8 kg.
Attention! SUPRA STV-LC40ST1000F LED TV panel V400HJ6-PE1 C3 is an expensive and unreliable element.
Do not allow any impacts on the glass and pressure on the screen surface to avoid damage to the LED panel!
It is also unsafe for liquid to spill onto the screen. Sometimes one drop is enough if it drips down the glass onto the cables to make the TV non-repairable.