Technical description and composition of the DNS V32D8100S TV, panel type and modules used. The composition of the modules.DNS LED
Model: V32D8100S
Chassis / Version: TP.SIS231.PT85
Panel: LSC320HN04-002 // DLED32-MZ-014
LED backlight: 13Y 32VNB USITSL4LV0.0 LEFT & RIGHT
T-CON: 13Y_S60TVAMB4C2LV0.0
LED driver (backlight): integrated into MainBoard
PWM LED driver: OB3350CP
MOSFET LED driver: AOD4454
Power Supply (PSU): integrated into MainBoard
PWM Power: PWM SOT23-6 LD7536
MainBoard: TP.SIS231.PT85
IC MainBoard: CPU: SIS231, DRAM: NT5CB64M16FP-DH, SPI Flash: 25Q64, TPA3110LD2, SI2168, RT7237
Control: IR: DLED32-ZJ-YKB-001
Specifications V32D8100S
DNS V32D8100S
General recommendations for TV LCD LED repair
Possible malfunctions
- DNS V32D8100S does not turn on and does not show any signs of operability at all. Does not blink indicators and does not respond to control buttons.
A malfunction in such cases, first of all, should be sought in the power elements of a switching power supply (SMPS) - a mains voltage converter (AC / DC), which in this TV model is combined with the main board MainBoard TP.SIS231.PT85. It is then necessary to measure its output voltages and, in their absence, the power switches and rectifier diodes of the converters should be checked for the probability of a short circuit.
In case of breakdowns in the secondary circuits of the converter, it can usually work in an emergency mode in a short-circuit mode, and with a short circuit in the power elements of the primary circuit, the mains fuse or current sensor in the source of the key most often breaks off.
Mos-Fet power switches used in switching power supplies sometimes fail due to a malfunction of any other elements that can disable it in the key mode, or create an excess of the maximum permissible key parameters. These can be elements supplying a PWM regulator, frequency setting or damper circuits, or elements of negative feedback in the stabilization circuit. PWM controllers PWM SOT23-6 LD7536, in the absence of visible damage or outright short circuits between the terminals, are checked by replacing them with new ones, or knowingly working properly.
- There is no image, there is sound, it reacts to the remote control. Or the image may appear for a second when turned on and disappear immediately.
Often, in such cases, there is no backlighting of the LED panel. The reason for this may be an open circuit in the LED circuit, or a problem in stabilizing their power supply.
When trying to detect a break in the LED lines, it should be borne in mind that it is difficult to do this without disassembling the panel. For example, a current source is needed to open PN junctions connected in series.
- The indicator on the front panel blinks, the TV does not turn on in operating mode, does not respond to the remote control.
Repair or diagnostics of the TP.SIS231.PT85 motherboard should begin with checking the stabilizers and power converters necessary to power the microcircuits and the matrix. If necessary, you should update or replace the software (software). When repairing an MB board, it is necessary to check its components CPU: SIS231, NAND: NT5CB64M16FP-DH, SPI Flash: 25Q64, TPA3110LD2, SI2168, RT7237. Defective elements must be replaced. If chips with BGA soldering technology are used, the problem in its implementation is detected by local heating of the chip.
Owners and users of the DNS V32D8100S TV should remember that self-repair without special knowledge, skills and qualifications may be fraught with negative consequences that can lead to the complete non-repairability of the device!
DOWNLOAD FIRMWARE FOR SPI FLASH -----------> DNS V32D8100S, Main: TP.SIS231.PT85, Panel: DLED32-MZ-014
DOWNLOAD SCHEMATIC DIAGRAM / SERVICE MANUAL ------------------> Power supply Chassis TP.SIS231.PT85
The appearance of the MainBoard TP.SIS231.PT851 is shown in the figure below:TP.SIS231.PT851
TP.SIS231.PT85 can be used in TVs:
DNS M39DM8 (Panel V390HJ1-P02 Rev C1), DNS S32DC1 (Panel T320XVD01.0), DNS E32D18 (Panel ST3151A05-5 CX315DLEDM), DNS V32D8100S (Panel LSC320HN04-002), ERISSON 40LEP92 (Panel LSC400HN01 G01), ROLSEN RL-39S1502T2C (Panel V390BJ1-L01-D00), RUBIN RB-40D5FT2C (Panel 390HJ5-XCPE1), RUBIN RB-40SE9FT2C (Panel CX400DLEDM), SUPRA STV-LC32T871WL (Panel JHD315GH-E31), SUPRA STV-LC40T871FL (Panel JHD400GF), TELEFUNKEN TF-LED32S26T2 (Panel MT3151A05).
Main features of the DNS V32D8100S device:
The matrix (LED panel) LSC320HN04-002 or DLED32-MZ-014 is installed.
Matrix control uses Timing Controller (T-CON) 13Y_S60TVAMB4C2LV0.0.
To power the backlight LEDs, a converter combined with the main board TP.SIS231.PT85 is used, controlled by the OB3350CP PWM controller. The keys of the AOD4454 type are used as power elements of the LED driver.
The power module is combined with the MainBoard and is made according to the AC / DC flyback voltage converter using PWM SOT23-6 LD7536 microcircuits.
MainBoard - the main board (motherboard) is a TP.SIS231.PT85 module, using CPU: SIS231 chips, DRAM: NT5CB64M16FP-DH, SPI Flash: 25Q64, TPA3110LD2, SI2168, RT7237 and others.
DNS TV V32D8100S with LCD DLED32-MZ-014, 32 "(81 cm) 16: 9. depending on the illumination of the areas in the scene.This model uses a panel with edge-mounted backlight LEDs - Edge LED.
The DLED32-MZ-014 matrix and the MainBoard TP.SIS231.PT85 software provide viewing of broadcasts and movies in high quality HD at a resolution of 1920x1080 pixels in graphics resolution at 1080p (Full HD). The input high-frequency or video signal is decoded in analog systems PAL, SECAM, NTSC. Graphic processing and formation of a digital signal occurs in the standards 480i, 480p, 576i, 576p, 720p, 1080i, 1080p. Supported media file formats: MP3, WMA, MPEG4, DivX, MKV, JPEG.
Speaker power 10 W (2x10 W) is provided by two speakers. The NICAM STEREO audio processing system is used.
External interface (communication with other devices) is supported by standard input and output connectors: antenna input (RF), AV, component, SCART, VGA, HDMI x4, MHL, USB. A headphone output is provided. To connect a computer or laptop to this TV model, use the VGA (D-Sub 15) connector on the TV case, this interface supports resolutions: 640x480, 800x600, 1360x768, 1920x1080. The digital tuner is capable of receiving television channels in DVB-T, DVB-C, DVB-T2 standards.
The TV uses a power supply unit as part of the MainBoard.
Dimensions: With stand 720x520x220 mm, Without stand 720x460x80 mm.
Attention! The panel DLED32-MZ-014 of the DNS V32D8100S LED TV is an expensive and unreliable element.
Do not allow any impact on the glass and pressure on the screen surface to avoid damage to the LED panel!
It is also unsafe for liquid to spill onto the screen. Sometimes one drop is enough if it drips down the glass onto the cables to make the TV unrepairable.