Simple Automatic Water Pump Controller Circuit Diagram is a series of functions to control the Automatic Water Pump Controller Circuit in a reservoir or water storage. As the water level sensor made with a metal plate mounted on the reservoir or water tank, with a sensor in the short to create the top level and a detection sensor for detecting long again made the lower level and ground lines connected to the bottom of reservoirs or reservoir.
The
series of automatic water pump controller is designed with 2 inputs NOR
by 4 pieces and relay that is activated by the transistor. Automatic
water pump circuit requires +12 VDC voltage source and can be used to
control the water pump is connected to AC power . Here is the complete
series of pictures.
Automatic Water Pump Controller Circuit Diagram
working
principle series of automatic water pump controller above is. At the
time the water level is below both sensors, the output IC1C (pin 10)
will be LOW, Kemudin when the water began to touch the lower level
sensor, the output IC1C (pin10) remains LOW until the water touches the
sensor level above, then the output IC1C (pin 10) going HIGH and active
relay through Q1 and turn on the water pump to meguras reservoir.
At
the muli down and water level sensors for water untouched MKA IC1C
output (pin 10) remains HIGH until the new water untouched semuasensor
IC1C output (pin 10) LOW and water pump died. The series of automatic
water pump controller is equipped with SW1 which serves to reverse the
logic of drains (the output of IC1C) and the concept of water supplied
(output dri IC1D).
When
SW1 is connected to IC1D the water pump will turn on when the water
does not touch all the sensors and will die when all the sensors
tesentuh water. Automatic water pump controller can be used to fill or
drain the water according to which mode is selected via SW1.
List Component Automatic Water Pump Controller
R1 = 15K
R2 = 15K
R3 = 10K
R4 = 1K
D1 = LED
D2 = 1N4148
Q1 = BC337
IC1 = 4001
SW = SPDT Switches
Relay RL1 = 12V