Before leaving the factory each oven is carefully checked. It must, however, be installed and used correctly.
Always disconnect the plug from the mains before starting work.
When you have finished servicing an oven before you reconnect it to the mains, make sure that:
- all the internal connections are correct
- the wires are insulated and not touching the door or the cabinet or anything sharp
- all the earth connections are electrically and mechanically sound
- do not modify or anyway interfere with the safety devices built-in to the oven.
Do not operate the oven if the following conditions exist:
- the door does not close firmly against the door support because of the door being warped or the hinges damaged.
- The door trims or seals are damaged.
- If there is any visible damage to the oven.
- if the door does not close properly.
Avoid operating the oven if known components in the interlock system, oven door or microwave generating assembly are known defective. They must be replaced.
Output power 950 W
Grill 900 W
Microwave frequency 2450 MHz
Error codes
Certain fault conditions are indicated by an error code.
The following codes are implemented:
ERR 0: Convection temperature sensor fault. Not connected or short circuit.
ERR 1: Short circuit in the MW relay.
ERR 6: Weight sensor calibration has not been performed.
ERR 7: Humidity sensor is defect or has not been connected.
ERR 8: Impossible to write to E2 PROM.
ERR 9: Options have not been set.
ERR A: No wheel detected on weight sensor.
ERR B: No pulses from the weight sensor or <4267 Hz.ERR C: Fuzzy temperature sensor fault. Not 19-41 ˚C.
Exploded view
Schematic diagram
Printed circuit board
Wiring diagram
