Technical description and composition of the TV MYSTERY MTV-1611LW, type of panel and applicable modules. The composition of the modules.MYSTERY LED
Model: MTV-1611LW
Panel: N156BGE-L21 Rev. C1 (BT156GW01 V.4)
T-CON: N156BG-L0A
LED driver (backlight): integrated into T-CON
Power Supply (PSU): Adapter 12V 4A
MainBoard: MSTV2401-ZC01-01 PN: 303C2401072
IC MainBoard: CPU: MST6E181VS-LF-Z1, SDRAM: H5DU2562GTR-E3C, SPI FLASH: S25FL032KIF, SOUND: YD1517P, TUNER: F33WT-3DDR-E
Tuner: F33WT-3DDR-E
Technical Specifications MTV-1611LW
MYSTERY MTV-1611LW
General repair guidelines for TV LCD LED
Possible manifestations of defects
- The MYSTERY MTV-1611LW TV does not turn on at all. The control lights do not light or flash. On the remote control and the buttons on the control panel does not respond.
Most often, with such manifestations, the main adapter power module is faulty.
This TV model is equipped with an external power adapter type Adapter 12V 4A, which the owner can purchase independently, and repairing it may not always be advisable, however, sometimes there is some reason to open it and eliminate simple typical defects typical of IIPS. In the absence of the necessary supply voltages in the secondary circuits of the converters, it is necessary first of all to check the power switches and rectifier diodes for a possible partial or complete breakdown.
In case of breakdowns in the secondary circuits, the converter can operate in a short circuit mode, and during a short circuit in the elements of the primary circuit, the mains fuse usually breaks.
The breakdown of Mos-Fet keys used in pulsed sources is often caused by malfunctions of other elements, for example, power supply, frequency-setting, damper ... as well as elements of the Negative Stabilization Feedback. The PWM chip can also cause a malfunction of the power switch of the converter and is checked by replacement.
- There is no image, there is sound, it is responding to the remote control. Or immediately after turning on for a second, the image may appear and immediately disappear.
In most cases, the malfunction is caused by the lack of a backlight display. The reason for this may be a break in the LED circuit, or a problem in stabilizing their power supply.
To check the health in the LED circuit, it is better to use a current source with a maximum voltage of 200V. We do not recommend using any voltage sources for this purpose. You can check each LED individually with a simple Chinese multimeter (powered by 9 volts) in the P-N-junction test mode. If you connect the red probe of the multimeter to the anode of the LED, and the black to its cathode, then the 3-volt LED will light up slightly, and in the opposite direction you can detect the transition of the emergency zener diode. A zener diode PN junction indirectly indicates a LED-a
- The TV does not enter the operating mode, does not respond to the remote control. The indicator on the front panel lights constantly or blinks.
Repair or diagnostics of the MSTV2401-ZC01-01 motherboard should begin by checking the stabilizers and power converters needed to power the chips and matrix. If necessary, update or replace the software (software). When repairing an MB board, you need to check its CPU components: MST6E181VS-LF-Z1, SDRAM: H5DU2562GTR-E3C, SPI FLASH: S25FL032KIF, SOUND: YD1517P, TUNER: F33WT-3DDR-E. Defective items should be replaced. If chips with BGA soldering technology are used, a problem in its implementation is detected by the local heating of the chip.
In the absence of tuning to the channels of on-air or cable television, you should make sure that the software is correct, as well as in accordance with the ratings of the supply voltages at the terminals of the F33WT-3DDR-E tuner. It is also necessary to check the presence of pulses of data exchange between the tuner and the processor via the I2C bus using an oscilloscope.
Attention to users! Self-repair of the MYSTERY MTV-1611LW TV without the appropriate qualifications and the necessary experience can lead to its complete non-repairability!
FIRMWARE FOR SPI FLASH -----------> MYSTERY MTV-1611LW - U17_S25FL032KIF
SCHEMATIC DIAGRAM / SERVICE MANUAL ------------------> MSTV2401-ZC01-01 (CPU: MST6E181VS)
The appearance of the MainBoard is shown in the figure below:MSTV2401-ZC01-01
MSTV2401-ZC01-01 can be used in TVs:
MYSTERY MTV-1611LW (Panel N156BGE-L21 Rev. C1 (BT156GW01 V.4)), MYSTERY MTV-1614LW (Panel CLAA156W811A).
Main features of the MYSTERY MTV-1611LW device:
Installed matrix (LED panel) N156BGE-L21 Rev. C1 (BT156GW01 V.4).
The matrix control uses the Timing Controller (T-CON) N156BG-L0A.
An integrated LED driver is used to power the backlight LEDs.
To power all the internal components of the MYSTERY MTV-1611LW TV, an external adapter type 12V 12V 4A is used.
MainBoard - the main board (motherboard) is an MSTV2401-ZC01-01 module, using CPU chips: MST6E181VS-LF-Z1, SDRAM: H5DU2562GTR-E3C, SPI FLASH: S25FL032KIF, SOUND: YD1517P, TUNER: F33WT-3D and others.
The F33WT-3DDR-E tuner provides TV reception and channel tuning.
Information from an alternative source:
MYSTERY MTV-1611LW
Panel Type (Matrix): CLAA156WB11A,
Motherboard: MSTV3208-ZC01-01, MST6M48RHS-LF-Z1, H5PS5162FFR, S25FL032KIF, MP1482DS, F4558, NX5DV330, TDA1517P, Tuner: F21WT-3BAR-E
Invertor: TV1601-ZC02-01 (A), MP1482DS [/ b], AO4435, AO4468, POWER: DC + 12V; 4A
Additional technical information about the panel:
Brand: CHIMEI INNOLUX
Model: N156BGE-L21 61 Compatible model
Type: a-Si TFT-LCD, Panel
Diagonal size: 15.6 inch
Resolution: 1366x768, WXGA
Display Mode: TN, Normally White, Transmissive
Active Area: 344.232x193.536 mm
Shape Style: Wedge (PCBA Bent, Depth? 5.2mm)
Surface: Glare (Haze 0%), Hard coating (3H)
Brightness: 220 cd / m²
Contrast Ratio: 650: 1
Display Colors: 262K (6-bit), CIE1931 60%
Response Time: 3/8 (Tr / Td)
Frequency: 60Hz
Lamp Type: WLED Embedded (LED Driver)
Signal Interface: LVDS (1 ch, 6-bit), 40 pins
Voltage: 3.3V
MYSTERY MTV-1611LW TV with N156BGE-L21 LCD, 16 "(41 cm) diagonal size of 16: 9 format. The required screen brightness of 250 cd / m² is provided by LED backlighting. Contrast, as the ratio of maximum brightness to minimum, is 1000: 1. Edge LED backlighting is realized in the LED-panel of this TV - Edge LED. You can view images in high quality HD at a resolution of 1366x768 pixels in the standard for graphic decomposition 720p (HD Ready). The input high-frequency or video signal can be processed in analog systems PAL, SECAM, graphic processing and digital signal generation are performed in 480i, 480p, 576i, 576p, 720p, 1080i standards. Supported media file formats: MP3, MPEG4, JPEG.
The power of the acoustic system of sound 6 W (2x3 W) provide two speakers. The audio processing system NICAM STEREO is used.
The external interface (communication with other devices) is supported by standard input and output connectors: antenna input (RF), AV, audio x2, component, SCART, RGB, VGA, HDMI, USB. To connect a computer or laptop to this TV model, a VGA (D-Sub 15) connector is used on the TV case, this interface supports resolutions: 800x600, 1024x768.
The power consumed by the TV in the operating mode from the network is 40 watts.
Dimensions: With stand 642x444x209 mm, Without stand 570x345x70 mm.
Attention! Panel N156BGE-L21 Rev. The C1 (BT156GW01 V.4) LED TV MYSTERY MTV-1611LW is an expensive and unreliable element.
Avoid any impact on the glass and pressure on the surface of the screen to avoid damage to the LED panel!
It is also unsafe to get liquid on the screen. Sometimes one drop is enough if it flows down the glass onto the cables so that the TV becomes unrepairable.
