PANASONIC KX-MB783-BR _ SERVICE CODES - TROUBLESHOOTING - INITIALIZATION
If, after the call is connected,
the customer describes the situation and it is determined that the problem can
be corrected by making parameter changes, this function makes it possible to
change parameters such as the user code and service code from another fax
(using DTMF tones). Therefore, travel to the customer's location isn't
required. However, it is not possible to change all the parameters remotely
(PROGRAM MODE TABLE(P.98)). The function used to accomplish this is remote
programming.
First, in order to check the current status of the service
code parameter, print out the setup list (code: 991) and the service list (code:
999) from the customer's fax machine.
Based on this, the parameters for the desired codes can be
changed.
The procedure for changing and listing parameters is
described on ENTERING THE REMOTE PROGRAMMING MODE AND CHANGING SERVICE CODES.
Also, before exiting the remote programming-mode, it is advisable to obtain a
new list to confirm that the changes were made correctly.
Hint: Since the
connected telephone is in use during the remote programming mode, it may be
helpful to ask the customer to switch to the speaker phone. This frees the
customer from the need to remain right next to the fax while you are making
parameter settings. When finished, inform the customer. Also note that in very
noisy locations where the DTMF tones are not audible, the remote programming
function will not work.
ENTERING THE REMOTE PROGRAMMING MODE AND CHANGING SERVICE CODES.
CLICK ON THE TABLES TO ZOOM IN
TROUBLESHOOTING
Troubleshooting is for recovering quality and reliability by
determining the broken component and replacing, adjusting or cleaning it as
required. First, determine the problem then decide the troubleshooting method.
If you have difficulty finding the broken part, determine which board is
broken. (For example: the Main PCB, Sensor PCB, etc.) The claim tag from a
customer or dealer may use different expressions for the same problem, as they
are not a technician or engineer. Using your experience, test the problem area corresponding
to the claim. Also, returns from a customer or dealer often have a claim tag.
For these cases as well, you need to determine the problem. Test the unit using
the simple check list on SIMPLE CHECK LIST(P.104). Difficult problems may be
hard to determine, so repeated testing is necessary.
Determine the symptom and the troubleshooting method.
INITIALIZATION
There are two types of initialization, one is the short
initialization (about 3 seconds) and the other is the long initialization
(about 10 seconds). The short initialization makes the unit enter the standby
mode. The long initialization makes the unit enter the standby mode after
cleaning or detecting the rest of toner.
