HOW TO DISASSEMBLE - PHILIPS HTS-3000_3150 - DVD HOME THEATER SYSTEM
DIS-ASSEMBLY
Dismantling of the Front Panel Assembly
1) Open the DVD Tray by using the Open/Close Button while
the Set is ON and disconnect the mains supply after removing the Tray Cover.
Note: If this is not possible, the DVD Tray has to
be open manually. Take a mini
screwdriver about 2mm diameter and make a marking 24mm from the tip
Place the set on its side, insert the mini screwdriver till
the marking and slide it towards the left until the Tray moves out of the Front
Panel.
2) Return the set to its upright position and remove the
Tray Cover and close the tray manually by pushing it back in.
3) Loosen 5 screws and remove the
Top Cover by lifting the
rear portion upwards before sliding it out towards the rear. - 3 screws
on the back - 1 screws each on the left & right side
4) Loosen 6 screws & lift up the top edge of Front Panel
assembly to free some catches before sliding it out towards the front. - 3 screws on the bottom 1 screw on the
inside - 1 screw each on the left &
right side.
Loosen 4 screws “ A “ on the top of main board as shown.
Loosen 4 screws “B” at the back panel as shown.
Power Board
Loosen 4 screws “D” at the top of the Power Board as shown.
DVD Module
Loosen 4 screws “E” to remove the DVD Module.
Note: In some service positions the components or copper
patterns of one board may risk touching its neighboring pc boards or metallic
parts. To prevent such short-circuit use a piece of hard paper or other
insulating material between them.