Media formats: AVCHD, BD, BD-R/ BD-RE, BD-Video, DVD-Video, DVD+R/+RW, DVD-R/-RW, DVD+R/-R DL, CD-R/CD-RW, Audio CD, storage device
Be
careful during measurements in the live voltage section. The primary side of
the power supply, including the heat sink, carries live mains voltage when you connect
the player to the mains (even when the player is “off”!). It is possible to
touch copper tracks and/or components in this unshielded primary area, when you
service the player. Service personnel must take precautions to prevent touching
this area or components in this area. A “lighting stroke” and a stripe-marked printing
on the printed wiring board, indicate the primary side of the power supply.
. Never replace modules, or components, while the unit is “on”.
Software
Upgrade
- 1. There are 2 ways to software upgrade:
- First:
- Upgrade from USB:
- Copy the upgrade file HTD5510_X X.BIN to USB then press the USB key on RC or SOURCE key on front panel.
- When upgrade file detected, select "Yes" to upgrade, select "Cancel" to cancel.
- After upgrading begins, a message “DO NOT POWER OFF” will show, or the product will hang up and upgrading failed.
- Second:
- Upgrade from Disc:
- Copy the upgrade file HTD5510_X X.BIN to disc then read the disc.
- When upgrade file detected, select "Yes" to upgrade, select “Cancel “to cancel.
-
After upgrading begins, a message “DO NOT POWER OFF” will show, or the product will hang up and upgrading
failed.
- 2. Check the version information after upgraded.
- Press the setup key on RC , select Preference Setup, and then Version info , press OK Key you will see a interface below:
Power board circuit diagram
Amplifier board circuit diagram
Amplifier board circuit diagram SL AND SW
Amplifier board circuit diagram DSP
Connector voltages