BBK LED
Model: 40LEX-5007 / FT2C
Chassis / Version: CV628H-T42
Panel: CV400FHD
LED driver (backlight): integrated into MainBoard
PWM LED driver: BIT3267
MOSFET LED driver: AOD4454
Power Supply (PSU): integrated into MainBoard
PWM Power: PWM SOT23-6 LD7536
MOSFET Power: SMK10N60
MainBoard: CV628H-T42
IC MainBoard: CPU: MSD6A628VXM-ST, NAND: KLM4G1FEPD, SPI FLASH: Winb25Q16JVSIQ, AUDIO: TPA3110LD2
Tuner: CDT-9NT372-RF01
Specifications 40LEX-5007 / T2C
BBK 40LEX-5007
General repair guidelines for TV LCD LED
Possible manifestations of defects
- The SUPRA STV-LC50T400FT does not turn on and does not show any signs of turning on. There is no reaction to the control buttons and the remote control.
In such cases, the SHG4202A-191S power supply is usually faulty. It is necessary to measure the secondary output voltage, and in case of their absence, check the serviceability of the power switches of the converters and rectifier diodes for a short circuit.
In case of breakdowns in the secondary circuits, the converter can operate in a short circuit mode, and during a short circuit in the elements of the primary circuit, the mains fuse usually breaks.
The breakdown of Mos-Fet keys used in pulsed sources is often caused by malfunctions of other elements, for example, power, frequency-setting, damper ... as well as elements of the Negative Stabilization Feedback. The PWM chip can also cause a malfunction of the power switch of the converter and is checked by replacement.
- There is no image, there is sound, it responds to the remote control, the channels are switched. In some cases, the image appears when you turn on and immediately disappears.
In most of these cases, a malfunction is detected in the nodes and backlight elements of the LED panel. The reason can be both in the power supply of the LEDs, in their serviceability (breakdown or breakage), as well as in the violation of the contact connections of the LED strips.
When trying to detect a break in the LED lines, it should be taken into account that it is difficult to do this without disassembling the panel. For example, a current source is needed to open PN junctions connected in series.
- The TV does not turn on, does not respond to the remote control. The indicator blinks or signals standby mode.
Repair or diagnostics of the HK-T.SP9202V51 motherboard should begin by checking the stabilizers and power converters needed to power the chips and matrix. If necessary, update or replace the software (software). Complex repair of MB (SSB) is possible only in the conditions of a service center with the necessary equipment. Testing or replacing Flash GD25Q32 elements requires the necessary training and professional skills to repair modules at the component level. Problems associated with the use of BGA soldering technologies can sometimes be diagnosed by warming up.
Attention! Users and owners of STV-LC50T400FT TVs who do not have the appropriate qualifications, knowledge and experience are strongly discouraged from attempting self-repair in order to avoid negative consequences that could lead to complete non-serviceability of the device.
Schematic Diagrams 14 pages of 2015 on -------------------> 32LEM-3081/T2C, 32LEX-5007/T2C, 32LEX-5025/T2C, 40LEX-5007/T2C, 40LEX-5007/FT2C, 40LEX-5025/FT2C, 40LEX-5035/FT2C, 43LEX-5007/FT2C, 50LEX-5022/FT2C, 50LEX-5025/FT2C, 55LEX-5022/FT2C
The appearance of the MainBoard CV628H-T42 is shown in the figure below:
CV628H-T42
CV628H-T42 can be used in TVs:
BBK 43LEX-5009/FT2C (Panel LC430DUY (SH)(A1)), BBK 40LEX-5025/FT2C (Panel V400HJ6-PE1 DLEDSV400FHD), BBK 32LEX-5027/T2C (Panel V320BJ6-Q01 Rev.C1), SUPRA STV-LC40ST900FL (Panel V400HJ6-PE1).
Main features of the BBK 40LEX-5007 device:
Installed matrix (LED-panel) CV400FHD.
To power the backlight LEDs, a converter is used, combined with the main board CV628H-T42, controlled by a BIT3267 PWM controller. As power elements of the LED driver, keys of the AOD4454 type are used.
The power module is combined with the MainBoard and is made according to the scheme of a flyback AC / DC voltage converter using PWM SOT23-6 LD7536 microcircuits and power switches of the SMK10N60 type.
MainBoard - the main board (motherboard) is a CV628H-T42 module, using CPU chips: MSD6A628VXM-ST, NAND: KLM4G1FEPD, SPI FLASH: Winb25Q16JVSIQ, AUDIO: TPA3110LD2 and others.
The tuner CDT-9NT372-RF01 provides the reception of television programs and tuning to channels.
Brand: BBK, Model: 40LEX-5007 / T2C.
Briefly from the TV: LCD, LED backlight, 40 ", 1366x768, 720p HD, DVR, sound: 20W, HDMI: 3, Internet access, Wi-Fi, Smart TV.
The composition uses MainBoard CV628H-T42 and LCD-panel CV400FHD. The power supply is combined with the MainBoard.
BBK 40LEX-5007 / T2C LED TV with CV400FHD LCD, 40 "(102 cm) diagonal, 16: 9 format. The required screen brightness of 250 cd / m² is provided by LED backlighting. The ratio of maximum brightness to minimum (contrast) is 4000: 1. The LED display is implemented in the model’s display manufacturing technology, and you can view images in high quality HD at a resolution of 1366x768 pixels in the standard of graphic decomposition 720p (HD Ready).
40LEX-5007 / T2C has built-in SMART Software and pre-installed Android Operating System. Connecting to the Internet can be done via Wi-Fi. The input high-frequency or video signal can be processed in analogue systems PAL, SECAM, NTSC. Graphic processing and digital signal generation occurs in the standards 480i, 480p, 576i, 576p, 720p, 1080i. Supported media file formats: MP3, WMA, MPEG4, MKV, JPEG.
The power of the acoustic system of sound 20 W (2x10 W) provide two speakers. It uses a NICAM stereo signal processing system and Sound Surround.
The external interface (communication with other devices) is supported by standard input and output connectors: antenna input (RF), AV, component, SCART, VGA, HDMI x3, MHL, USB x3, Ethernet (RJ-45), Wi-Fi 802.11n. An output for connecting headphones is provided. To connect a computer or laptop to this TV model, a VGA (D-Sub 15) connector is used on the TV case, this interface supports resolutions: 640x480, 800x600, 1024x768, 1280x1024, 1360x768, 1920x1080. A digital tuner is capable of receiving television channels in the DVB-T MPEG4, DVB-C, DVB-T2 standards.
Overall dimensions: with stand 927x591x212 mm, without stand 927x545x90 mm.
The mass of the TV: 9.4 kg.
Attention! The CV400FHD panel of BBK 40LEX-5007 / T2C LED TV is an expensive and unreliable element.
Avoid any impact on the glass and pressure on the surface of the screen to avoid damage to the LED panel!
It is also unsafe to get liquid on the screen. Sometimes one drop is enough if it flows down the glass onto the cables so that the TV becomes unrepairable.