SONY
Model: KDL-32V5610
Panel: LTY320HA02
Power Supply (PSU): PSC10265H M (147415312-00078251)
PWM Power: SSC9503, STR-A6079M, PS256
MainBoard: 1-878-942-12 (A-1663-964-B)
IC MainBoard: MC10144F1, K9F1208U0C, K4T51163QG, 24C32, MB91F313A, TAS5602
Tuner: BTD-HF422T
Control: IR: A-1671-630-A (1-879-367-11)
Technical Specifications KDL-32V5610
SONY KDL-32V5610
The SONY KDL-32V5610 TV does not turn on. There are no signs of operability. The indicators on the front panel do not light or flash, the TV does not respond to the remote control and control buttons.
With such manifestations, in some cases, the PSC10265H power module is faulty. It is necessary to measure its output voltages, and in case of their absence (full or partial), it is necessary to check the serviceability of the power switches of the converters and rectifier diodes for the presence of a possible short circuit.
In case of breakdowns of semiconductors in the secondary circuits of any converter, as a rule, it can operate in emergency short-circuit mode without output voltages, and during short circuit in the elements of the primary circuit, the main fuse and, less often, the current sensor at the source of the key most often breaks.
The breakdown of Mos-Fet keys used in pulsed sources is often caused by malfunctions of other elements, for example, in the power supply circuit of a PWM controller, in frequency-setting or damping circuits, as well as in Negative Stabilization Feedback. PWM microcircuits SSC9503, STR-A6079M, PS2561 are usually checked by replacing with new, or obviously working.
- There is no image, but there is sound, it reacts to the remote control. Or the image appears when you turn it on and immediately disappears
These manifestations can be triggered by the power module, or by inverter defects, as well as by the distortion of the currents in the lamps due to their uneven wear. After checking all the electrolytic capacitors of the filters that are involved in the power supply of the inverter, it is necessary to ring in its converter the power switches for breakdown and the secondary windings of the transformers for an open.
If in diagnosing a malfunction, it is necessary to disable the inverter protection, there is a risk of failure of the power elements of the inverter, and special care is required during work, and after they are finished, it is necessary to restore the protection circuits for further safe operation of the TV by the owner in normal mode.
- The TV does not enter the operating mode, does not respond to the remote control. The indicator on the front panel lights constantly or blinks.
Repair or diagnostics of the motherboard 1-878-942-12 should begin by checking the stabilizers and power converters needed to power the microcircuit and matrix. If necessary, update or replace the software (software). Complex repair of MB (SSB) is possible only in the conditions of a service center with the necessary equipment. Checking or replacing CPU elements: MC10147F1 410, MB91F313A, NAND Flash: K9F1208UOC, EEPROM: 24C32 requires the necessary training and professional skills to repair modules at the component level. Problems associated with the use of BGA soldering technologies can sometimes be diagnosed by warming up.
The malfunction of the BTFBG442T 8-597-708-00 tuner is established after checking the software and all the supply voltages at its terminals. The data exchange of the tuner with the processor via the I2C bus can be controlled by an oscilloscope.
Owners and users of the SONY KDL-32V5500 TV should remember that self-repair without special knowledge, skills and qualifications can be fraught with negative consequences that can lead to complete non-repairability of the device!
schematic diagram -------------------> SONY KDL-32V5610 Chassis EX2L-Coriander
General recommendations for repairing TV LCD
Repair MainBoard
The appearance of MainBoard 1-878-942-12 is shown in the figure below:
1-878-942-12
1-878-942-12 can be used on TVs:
SONY KDL-46V5500 (Panel LTY460HB11), SONY KLV-32V550A (Panel LTY320HA03 A06), SONY KLV-40V550A (Panel LTY400HA12), SONY KLV-52V550A (Panel LTY520HB11), SONY KDL-46V5610 (Panel LTY460HB10), SONY KDL-32V5610 (Panel LTY320HA02), SONY KDL-32V5500 (Panel LTY320HA02).
The appearance of the power supply
Main features of the device SONY KDL-32V5610:
Installed matrix (LCD panel) LTY320HA02.
The necessary supply voltages for all nodes of the SONY KDL-32V5610 TV are generated by the PSC10265H power supply module or its analogs using SSC9503, STR-A6079M, PS256 microcircuits.
MainBoard - the main board (motherboard) is a module 1-878-942-12, using microchips MC10144F1, K9F1208U0C, K4T51163QG, 24C32, MB91F313A, TAS5602 and others.
The BTD-HF422T tuner provides TV reception and channel tuning.
Additional technical information about the panel:
Brand: S-LCD
Model: LTY320HA02
Type: a-Si TFT-LCD, Panel
Diagonal size: 31.5 inch
Resolution: 1920x1080, FHD