DENON DN-X300 DJ MIXER DISASSEMBLING AND CIRCUIT DIAGRAM
DJ MIXER
DISASSEMBLING AND CIRCUIT DIAGRAM
DISASSEMBLE PROCEDURE
1. Top Panel
(1) Pull out the Knobs from the Top Panel.
(2) Remove the 6 screws attaching the Top Panel.
(3) Pull up the Front Panel.
(1) Pull out the Knobs from the Top Panel.
(2) Remove the 6 screws attaching the Top Panel.
(3) Pull up the Front Panel.
2. Crossfader Unit
(1) Remove the 2 screws attaching the Crossfader Unit.
(2) Pull up the Crossfader Unit and disconnect the connector.
(1) Remove the 2 screws attaching the Crossfader Unit.
(2) Pull up the Crossfader Unit and disconnect the connector.
3. Channel Fader Unit
(1) Remove the 3 screws attaching the Channel Fader Unit.
(2) Pull up the Channel Fader Unit and disconnect the connector.
(1) Remove the 3 screws attaching the Channel Fader Unit.
(2) Pull up the Channel Fader Unit and disconnect the connector.
4. Input Selector
Unit
(1) Remove the 2 screws attaching the Input Selector Unit.
(2) Pull up the Input Selector Unit and disconnect the connector.
(1) Remove the 2 screws attaching the Input Selector Unit.
(2) Pull up the Input Selector Unit and disconnect the connector.
5. Top Panel Unit
(1) Remove the 6 screws from the both-sides side.
(2) Remove the 2 screws from the rear side.
(3) Remove the 5 screws from the front side.
(4) Remove the 4 screws from the bottom side.
(5) Pull up the front side of the Top Unit.
(6) Disconnect the connectors.
(1) Remove the 6 screws from the both-sides side.
(2) Remove the 2 screws from the rear side.
(3) Remove the 5 screws from the front side.
(4) Remove the 4 screws from the bottom side.
(5) Pull up the front side of the Top Unit.
(6) Disconnect the connectors.
CIRCUIT DIAGRAM
MIXER UNIT AND PHONE UNIT
CPU UNIT - FADER START UNIT - REVERSE UNIT - CH VR UNIT
OUTPUT UNIT - JACK UNIT - TRANS UNIT
CLICK ON THE IMAGES TO ZOOM IN