SAMSUNG WS23Z30HP _ EUROPE _ SERVICE MODE
TO ENTER SERVICE MODE
- Press the keys on the remote control according to the following sequence. (In Stand-by status).
- [ Info àMenu à Mute àPower On ]
- When failing to enter Service Mode, repeat the procedure above.
INITIAL SCREEN OF SERVICE MODE [EUROPE]
- Deflection
- 480p/576p
- 720p/1080i
- 4:3 offset--Vixlm
- Video Adkust1
- Video Adkust2
- Video Adkust3
- Video Adkust4
- Video Adkust5
- Video Adkust6
- Video Adkust7
- Video Adkust8
- OPTION (55 OB 00)
- YC Delay
- EEPROM
- Bus Stop
- Checksum 0000
- RESET
BUTTON FUNCTIONS IN SERVICE MODE
- Menu [Up / Dn] à Move the cursor to select an item.
- Menu [Right / Left] à Adjust the selected configuration value.
- Menu à Show all menus.
DEFLECTION ADJUSTMENTS [SCREENS TO COMPARE]
MAIN BOARD
The System Board that
Controls Various Signals for Video Signal Processing and Product Operations.
- CN601 : This is a 4 pin port connected to the Speaker, and sends the signal from the AMP to the speakers.
- CN403 : This is a 8 pin port connected to the CRT Board and supplies 200V, +16V, -16V and Heater voltage.
- GT804 : This is a ground port to prevent high voltage due to lighting.
- CN802 : This is a 3 pin port connected to the AC power cable. It is connected to the power cable socket.
- GT805, GT806 : This is a port connected to the D-Coil surrounding the CRT.
FEATURE BOX BOARD
This controls the path
of the electron beams from the CRT electron guns using the deflection coil.
- CN07 : This is a 14 pin port connected to the CRT Assy's, and outputs final R/G/B signals to the CRT Ass'y. In addition, it outputs the Tilt, VM, and Power signals for the CRT Drive.
- CN05 : This is a 4 pin port connected to the Control Ass'y, and receives TV/Video, Menu, Ch Up/Down and Vol -/+ signals.
- CN04 : This is a 6 pin port connected to the Master Ass'y, and receives Master Power On/Off, and IR signals.
- CN03 : This is a 8 pin port connected to the Side AV, and receives S-Video2 and AV4 external inputs.
CRT BOARD ASS'Y
This supplies the
final R/G/B signal from the F-Box and the CRT deflection signal to the CRT.