JBLPARTYBOX100AM,JBLPARTYBOX100AS,JBLPARTYBOX100CN,JBLPARTYBOX100EU, JBLPARTYBOX100JN,JBLPARTYBOX100IN,JBLPARTYBOX100BR,JBLPARTYBOX100RU
Audio Amplifier Section
Set
all additional processing (tone controls, equalizers, audio effects, etc) to
native or bypass, Set Unit on Test mode, set digital generator either off if not additionally defined.
Output resistive load = 4Ω, 2 channels loaded. All voltage measurements are
made with RMS detector,1kHz signal,10Hz~22kHz
BW, unless otherwise specified.
Speaker Output(Aux-in and BT/USB)
Short circuit, overvoltage and thermal protection
Software upgrade and system Reset
Restore factory setting
1.
Power on, Hold down<PLAY> and <VOLUME +>keys on the top panel
about 10 seconds.
2. Then, the unit will power off, the reset successful.
3. After factory settings restored, the unit will reboot automatically.
Check software Version
1. Power on, the unit is nothing input( No BT
connection / No USB play / No AUX IN input.
2. Hold down <BASS BOOST> & <VOLUME - > keys on the top panel
about 2 seconds.
3. The unit will voice playback software version.
4. The unit will exit the SW version speech mode automatically.
Software Upgrade via USB
1.
Copy the firmware file (XXX.bin) into a USB flash drive.
2. Insert the USB flash drive to the set.
3. Hold down <VOLUME+> and < BT > keys on the top panel about 10
seconds. The right woofer LED will show red.
4. Starting to upgrade, The right woofer LED colour to white. White LED will
display the upgrade progress.
5. Then, the unit will power off , the upgrade successful.
6. The unit will reboot automatically.
Disassembly procedures
How to dismantle PCBs
Dismantling of lighting PCBA and speaker drivers
Schematic diagram: Battery charge circuit
Circuit Diagram-MCU+DSP+AMP PCBA
Circuit Diagram-MCU+DSP+AMP PCBA
Power board (SMPS) schematic