LG
Model: 32CS465 ZA
Chassis / Version: LC21B / LD21C
Panel: LC320WXN (SC) (A4)
T-CON: 6870C-0313C LC320WXN-SCA2 CONTROL; LG5804B, TPS65163
Inverter (backlight): 6632L-0637A 3PEGA20004A-R VITIAZ10.5
PWM Inverter: OZ9966SN
MOSFET Inverter: AOD4184
Trans Inverter: T1-EH32-A
Power Supply (PSU): EAX64604501 (1.7) LGP32-12P
PWM Power: L6599AD, HS01G, FSL106HR
MOSFET Power: 10M60N
MainBoard: EAX64910001 (1.0)
IC MainBoard: CPU: LGE2111A-T8, Nand: H27U1G8F2BTR, DDR: K4B1G1646G-BCK0, SPI: 25Q80
Tuner: TDSS-G101D
Control: IR: EBR74561001 LM35-55 Ver 1.5
Specifications 32CS465
LG 32CS465
General recommendations for repairing TV LCD
Possible malfunctions
- LG 32CS465 TV does not turn on at all. There is no reaction to the remote control and control buttons from the front panel. Indicator lights do not light or flash.
With such manifestations, in some cases, the EAX64604501 power module is faulty. It is necessary to verify the presence of its output voltages and, if they are completely absent, check the power switches (10M60N) and rectifier diodes for a probable short circuit.
In case of any breakdowns in the secondary circuits, the converter can operate in emergency short circuit mode, and during short circuit in the power elements of the primary circuit, the mains fuse or the current sensor at the source of the key more often breaks.
The breakdown of Mos-Fet keys used in pulsed sources is often caused by malfunctions of other elements, for example, in the power supply circuit of a PWM controller, in frequency-setting or damping circuits, as well as in Negative Stabilization Feedback. PWM microcircuits (PWM) L6599AD, HS01G, FSL106HR are usually checked by replacing with new ones, or obviously working.
- There is no image, there is sound, it is responding to the remote control. Or immediately after turning on for a second, the image may appear and immediately disappear.
The defect can be caused by problems in the nodes or elements of the backlight of the display, or in the power supply of the lamps or inverter. If all the electrolytic capacitors of the filter according to the power supply of the inverter are working, make sure that the lamps are working, then you need to check the converter keys and the secondary windings of the transformers.
If in diagnosing a malfunction, it is necessary to disable the inverter protection, there is a risk of failure of the power elements of the inverter, and special care is required during work, and after they are finished, it is necessary to restore the protection circuits for further safe operation of the TV by the owner in normal mode.
- The indicator on the front panel blinks, the TV does not turn on in the operating mode, it does not respond to the remote control.
Repair or diagnostics of the EAX64910001 motherboard should begin by checking the stabilizers and power converters needed to power the chips and matrix. If necessary, update or replace the software (software). Complex repair of MB (SSB) is possible only in the conditions of a service center with the necessary equipment. Checking or replacing CPU elements: LGE2111A-T8, Nand: H27U1G8F2BTR, DDR: K4B1G1646G-BCK0, SPI: 25Q80 requires the necessary training and professional skills to repair modules at the component level. Problems associated with the use of BGA soldering technologies can sometimes be diagnosed by warming up.
The TDSS-G101D tuner malfunction is established after checking the software and all supply voltages at its terminals. The data exchange of the tuner with the processor via the I2C bus can be controlled by an oscilloscope.
TV users and owners need to remember that attempts to self-repair an LG 32CS465 TV without the appropriate qualifications and necessary experience can lead to serious negative consequences!
SCHEMATIC MANUAL -----> LG 32CS460/460S/460T/463/465, 32CS460-ZA/460S-ZA/460T-ZA/463-ZA/465-ZA Chassis LD21C
The appearance of the MainBoard EAX64910001 is shown in the figure below:
EAX64910001
EAX64910001 can be used in TVs:
LG 32LS340T (Panel LC320DXN), LG 32LS3510-ZB (Panel LC320EXN SEA2), LG 42CS460 (Panel LC420WUE (SC)(A3)), LG 32LS350T ZA (Panel T320XVN01.1), LG 42LS345T (Panel HC420DUN-SLCP1 11XX), LG 32CS465 ZA (Panel LC320WXN (SC)(A4)), LG 32LS345T (Panel 331537561 KENMOS 1365X768).
The appearance of the power supply
Main features of the device LG 32CS465:
Installed matrix (LCD panel) LC320WXN (SC) (A4).
The matrix control uses the Timing Controller (T-CON) 6870C-0313C.
To power the backlight, an inverter 6632L-0637A is used, it is controlled by the PWM controller OZ9966SN. The transformer T1-EH32-A is installed in the inverter converter. As power elements of the inverter, keys of the AOD4184 type are used.
The necessary supply voltages for all nodes of the LG 32CS465 TV are generated by the EAX64604501 power module or its analogs using L6599AD, HS01G, FSL106HR microcircuits and 10M60N power switches.
MainBoard - the main board (motherboard) is an EAX64910001 module using CPU chips: LGE2111A-T8, Nand: H27U1G8F2BTR, DDR: K4B1G1646G-BCK0, SPI: 25Q80 and others.
The TDSS-G101D tuner provides TV reception and channel tuning.
Additional technical information about the panel:
Brand: LG Display
Model: LC320WXN-SCA4
Type: a-Si TFT-LCD, Panel
Diagonal size: 31.5 inch
Resolution: 1366x768, WXGA
Display Mode: S-IPS, Normally Black, Transmissive
Active Area: 697.685x392.256 mm
Surface: Antiglare (Haze 10%), Hard coating (3H)
Brightness: 450 cd / m²
Contrast Ratio: 1200: 1
Display Colors: 16.7M (8-bit), CIE1931 72%
Response Time: 8 (G to G)
Frequency: 60Hz
Lamp Type: EEFL Embedded (Inverter)
Signal Interface: LVDS (1 ch, 8-bit), 30 pins
Voltage: 12.0V