LG
Model: 32LD425
Chassis / Version: LD01B
Panel: LC320WUG (SC) (A1)
Inverter (backlight): integrated into PSU
PWM Inverter: BD9270F
Power Supply (PSU): EAX61124202 / 2
PWM Power: STR-W6053N, HS01G (PFC)
MOSFET Power: 10NM60N
MainBoard: EAX61354204 (0)
IC MainBoard: CPU: LGE107DC-RP, DDR: H5TQ1G63BFR-H9C, Nand: HY27UF082G2B, SPI FLASH MX25L8005M2I
Tuner: TDTJ-S001D
Specifications 32LD425
LG 32LD425
General recommendations for repairing TV LCD
Possible malfunctions
- The LG 32LD425 TV does not turn on and does not show any signs of operability at all. There is no reaction to the remote control and control buttons from the front panel.
With such manifestations, the EAX61124202 power module usually fails. It is necessary to measure the output voltages in its secondary circuits, and if they are completely absent, check the serviceability of the power switches (10NM60N) and rectifier diodes for possible breakdown (short circuit).
In case of diode breakdowns in the secondary circuits, the converter can operate in emergency short-circuit mode without output voltages, and during short circuit in the power elements of the primary circuit, the mains fuse and / or current sensor at the source of the key usually breaks.
Mos-Fet keys used in switching power supplies usually fail due to a malfunction of other elements that can put it out of operation in key mode or provoke an excess of the maximum current or voltage. These can be circuits supplying the PWM controller, damping or frequency-setting circuits, or elements of OOS (negative feedback) in the stabilization circuit. PWM controllers (PWM) STR-W6053N, HS01G (PFC), in the absence of external damage and short circuit between the terminals, are checked by replacing with obviously good ones.
- There is no image, but there is sound and reaction to the remote control. Or for a second, the image may appear immediately after switching on.
The defect can be caused by problems in the nodes or elements of the backlight of the display, or in the power supply of the lamps or the inverter.After checking all the electrolytic capacitors of the filters that are involved in the power supply to the inverter, you must ring in its converter power keys for breakdown and secondary windings of transformers for an open.
Sometimes, for diagnostic purposes, it is necessary to disable the inverter protection. In such cases, special care must be taken during work, and the protection circuits should be restored immediately after the repair is completed.
- The TV does not turn on, does not respond to the remote control. The indicator blinks or signals standby mode.
Repair or diagnostics of the EAX61354204 motherboard should begin by checking the stabilizers and power converters needed to power the chips and matrix. If necessary, update or replace the software (software). If it is not possible to replace the MB (SSB) card, you need to check the health of its elements - CPU: LGE107DC-RP, DDR: H5TQ1G63BFR-H9C, Nand: HY27UF082G2B, SPI FLASH MX25L8005M2I. Defective components should be replaced.
If there is no reception of television channels, but the TV is working properly from external devices, first of all you need to check the power supply of the TDTJ-S001D tuner and update the software. The pulses from the I2C bus must be controlled with an oscilloscope.
Attention TV owners! Attempts at self-repair of LG 32LD425 are not recommended by the manufacturer and can lead to serious negative consequences!
The appearance of the MainBoard EAX61354204 is shown in the figure below:
EAX61354204
EAX61354204 can be used in TVs:
LG 32LD345 (Panel LC320WXE-SCA1), LG 37LD450 (Panel LC370WUG (SC)(A1)), LG 42LD455-ZA (Panel LC420WUG), LG 32LD550 (Panel LK315D3LA57), LG 42LD450 ZA (Panel LC420WUG (SC)(A1)), LG LG32LD350 32LD350 (Panel T315HW04 V.8), LG 42LD420 ZA (Panel LC420WUG (SC)(A1)), LG 37LD420 ZA (Panel T370HW03 V.B), LG 32LD420 ZA (Panel LC320WUG (SC)(A1)), LG 32LD555 ZC (Panel LC320WUG (SC)(A1)), LG 26LD355-ZA (Panel T260XW04 V.3), LG 37LD425 ZA (Panel T370HW03 V.B), LG 32LD425 (Panel LC320WUG (SC)(A1)), LG 32LD340 32LD340-ZA.BRUWLJU (Panel LC320WXE (SC)(A1)).
The appearance of the power supply
Main features of the device LG 32LD425:
Installed matrix (LCD panel) LC320WUG (SC) (A1).
To power the backlight, a converter is used, combined with the power supply, controlled by the BD9270F PWM controller.
The necessary supply voltages for all nodes of the LG 32LD425 TV are generated by the EAX61124202 power module or its analogs using STR-W6053N, HS01G (PFC) microcircuits and 10NM60N type power switches.
MainBoard - the main board (motherboard) is an EAX61354204 module using CPU chips: LGE107DC-RP, DDR: H5TQ1G63BFR-H9C, Nand: HY27UF082G2B, SPI FLASH MX25L8005M2I and others.
The TDTJ-S001D tuner provides TV reception and channel tuning.
Additional technical information about the panel:
Brand: LG Display
Model: LC320WUG-SCA1
Type: a-Si TFT-LCD, Panel
Diagonal size: 31.5 inch
Resolution: 1920x1080, FHD
Display Mode: S-IPS, Normally Black, Transmissive
Active Area: 698.4x392.85 mm
Surface: Antiglare (Haze 10%), Hard coating (3H)
Brightness: 500 cd / m²
Contrast Ratio: 1500: 1
Display Colors: 1.06B (8-bit + FRC), CIE1931 72%
Response Time: 8/10 (Tr / Td)
Frequency: 60Hz
Lamp Type: 14 pcs EEFL Without Driver
Signal Interface: Mini LVDS, 120 pins
Voltage: 3.3 / 16V (VCC / VDD)