PHILIPS FW-C399 Mini System - Disc Changer Mechanism Repair Procedure
Disc Changer Mechanism [CASEROL] Repair Procedure - Philips FW-C399 Mini System-3CDC
MODULE How to take disc out when there is no power [Emergency Open]
From production wk224
onwards a new 3CDC-LLC-DA11 module with Sanyo DA11 Drive is introduced as an
alternative module.
The new module can be
recognized by:
* the label on the left side of the module
* the additional housing over one of the toothed wheels as shown in the picture below.
* the additional housing over one of the toothed wheels as shown in the picture below.
The following steps have
to be done when replacing the CD mechanism
1 Disconnect flex foil cable from the old CD drive
2 Put a paper-clip on the flex foil to short-circuit the contacts (fig.1)
3 Remove the old CD drive
4 Remove paper-clip from the flex foil and connect it to the new drive
5 Position the new CD drive in its studs
6 Remove solder joint from the Laser unit
1 Disconnect flex foil cable from the old CD drive
2 Put a paper-clip on the flex foil to short-circuit the contacts (fig.1)
3 Remove the old CD drive
4 Remove paper-clip from the flex foil and connect it to the new drive
5 Position the new CD drive in its studs
6 Remove solder joint from the Laser unit
[The laser diode of this
CD drive is protected against ESD by a solder joint which short circuits the laser diode to ground.
For proper functionality of the CD drive this solder joint must be removed after connection the drive to the set.]
For proper functionality of the CD drive this solder joint must be removed after connection the drive to the set.]
EMERGENCY OPEN
In case of a Supply fault, the tray can be opened manually.
1 Remove the top cover of the set to get access to the Changer Module.
2 Turn gearwheel clockwise (as shown in picture below).
1 Remove the top cover of the set to get access to the Changer Module.
2 Turn gearwheel clockwise (as shown in picture below).
DISMANTLING THE TRAY
1 Open the tray.
2 Release 2x catch as shown in fig. 2 and Detail A
3 Pull tray out.
2 Release 2x catch as shown in fig. 2 and Detail A
3 Pull tray out.
ASSEMBLING THE TRAY
1 Turn Cam (pos. 48)
clockwise to end position.
2.If necessary - move Guiding (pos. 49) to the right end position.
3.Insert the Tray.
2.If necessary - move Guiding (pos. 49) to the right end position.
3.Insert the Tray.