SHARP LC26GA3E SERVICE MODE
The adjustment values are set to the optimum conditions at the factory before shipping. If a value should become improper or an adjustment is required due to part replacement, make an adjustment according to the following procedure.
After replacement of any PWB unit
and/or IC for repair, please note the following.
When replacing the PWB and IC, pay attention to the following precautions.
When replacing units below, order those where the software has been written.
DVI unit : DUNTKC595FE50
CPU unit : DUNTKC427FE20
LCD CONTROLLER unit : DUNTKC268FE86
When replacing the PWB and IC, pay attention to the following precautions.
When replacing units below, order those where the software has been written.
DVI unit : DUNTKC595FE50
CPU unit : DUNTKC427FE20
LCD CONTROLLER unit : DUNTKC268FE86
Upgrading of each microprocessor
software
Caution: Never "POWER
OFF" the unit when software upgrade is ongoing.
Otherwise the system may be damaged beyond recovery.
Otherwise the system may be damaged beyond recovery.
Software version upgrade
This unit has main and monitor microcomputer softwares.
These can be rewritten via a general-purpose SD memory card.
The procedures to rewrite the main and monitor microcomputer softwares are described below.
This unit has main and monitor microcomputer softwares.
These can be rewritten via a general-purpose SD memory card.
The procedures to rewrite the main and monitor microcomputer softwares are described below.
Main software version upgrade
SD memory card of 16MB or higher capacity
PC running on Windows 98/98SE/ME/2000/XP operating system
SD memory card reader/writer with USB connectivity and PC card adapter
SD memory card formatting software
PC running on Windows 98/98SE/ME/2000/XP operating system
SD memory card reader/writer with USB connectivity and PC card adapter
SD memory card formatting software
Entering and exiting the
adjustment process mode (SERVICE)
1. Before entering the adjustment process
mode, press the "TV RESET" button or execute the AV position RESET in the video adjustment menu.
2. Pull out the AC cord to turn off the TV.
3. While holding down the "VOL (–)" and "INPUT" keys at a
time, press the POWER switch of the main unit to turn on the power.
The letter " K " appears on the screen.
The letter " K " appears on the screen.
4 Press the "VOL (–)" and CH (V) keys at the same time. When multiple lines of blue letters are displayed on the screen, the unit has
entered the process adjustment mode. If the unit does not enter the process adjustment mode (if the same display as
the normal start appears), try again.
5. To exit the adjustment process mode after the adjustment is done, unplug the
AC cord from the outlet to make a forced shutdown. (When the power was turned off with the remote
controller, once unplug the AC cord and plug it again. In this case, wait 10 seconds or so before plugging.)