Apple iPhone battery replacement procedure – Apple iPhone 4s Battery replacement
Apple iPhone 4s
battery replacement procedure
Before
disassembling your iPhone, be sure it is powered off. Your iPhone 4 rear cover
may have either two #000 Phillips screws or Apple's 5-Point
"Pentalobe" screws (second image). Check which screws you have, and
ensure you also have the correct screwdriver in order to remove them.
Remove the two 3.6 mm Pentalobe or Phillips #000 screws next to the dock connector. During reassembly, we recommend you replace the 5-point screws with equivalent Phillips screws. Our Liberation Kit provides the tools and screws needed to replace the Pentalobe screws with Phillips screws.
The 5-Point Screwdriver should only be used once, as it has the potential to strip the screws.
Remove the two 3.6 mm Pentalobe or Phillips #000 screws next to the dock connector. During reassembly, we recommend you replace the 5-point screws with equivalent Phillips screws. Our Liberation Kit provides the tools and screws needed to replace the Pentalobe screws with Phillips screws.
The 5-Point Screwdriver should only be used once, as it has the potential to strip the screws.
Push
the rear panel toward the top edge of the iPhone. The panel will move about 2
mm.
Pinch
the rear panel with your fingers and lift it away from the iPhone. Alternatively,
use a Small Suction Cup . Be careful not to damage the plastic clips
attached to the rear panel.
If
you are installing a new rear panel, be sure to remove the plastic protective
sticker from the inside of the camera lens and the sticker from the large black
area near the lens.
Remove
the single 2.5 mm Phillips screw securing the battery connector to the logic
board. Some devices may have two screws, one of which holds down the contact
pad which is located above the screw indicated in red in the photo.
Use
a plastic opening tool to gently pry the battery connector up from its socket
on the logic board. Pry from the top and bottom of the connector bracket there
isn't as much of an overhang on the sides, and you may damage the connector.
Be very careful to only pry up on the battery connector and not the socket on
the logic board. If you pry up on the logic board socket, you may break it
entirely. Remove the metal clip covering the antenna connector.
Use
the clear plastic pull tab to gently lift the battery out of the iPhone. Do not
remove the plastic tab from the iPhone. You may need to use a plastic opening
tool to loosen the adhesive under the battery. Remove the contact clip from the
iPhone. Before reconnecting the battery connector, be sure the contact clip
(shown in red) is properly positioned next to the battery connector. Before
reassembly, be sure to clean all metal-to-metal contact points on the pressure
contact as well as its contact point on the rear panel with a de-greaser such
as windex. The oils on your fingers have the potential to cause wireless
interference issues.