PANASONIC PT47WXD63 PT53TWD63 PT56TWD63 FIRMWARE UPDATE
THERE ARE TWO OPTIONS TO UPDATE THE FIRMWARE
- Customer can download the firmware and do the update themselves.
- Customer can call for service.
MASS PRODUCTION VERSION FIRMWARE
- Ver 1.4.4 {early version}
- Ver 1.5.0 [Optical Digital Audio Output Correction]
- Wit unit that contain firmware version 1.4.4 may upgrade to version 1..5.0 by going to Panasonic website.
FIRMWARE UPGRADE - WEB DOWNLOADS
This firmware update addresses functionality issues with the optical digital audio output.
Models Affected: PT-47WXD63 _ PT-53WXD63 _ PT-53TWD63 _ PT-56TWD63
Go to Panasonic Website < www.panasonic.com >
- Download the zip file {TXFSD01GSER.zip} under customer product | Support | Downloads | Projection TVs
- Unzip the file and save it to SD card (over 16MB needed). When unzipping the file, make sure the extract "All Files" with "User Folder Names".
- Remove SD card from the computer.
- Unplug the TV from wall outlet.
- Insert the SD card into the SD card slot located at the back, which says "Service Only".
- Plug the unit into wall outlet, and turn ON the unit.
- Wait until the unit is turned ON. It might take more than minute. When the unit turns ON, wait and confirm the screen below. Press "OK" to start the firmware upgrade to begin. {Do Not turn OFF the unit until upgrade is completed.
SD download information
|
|||
SD card
|
TV set
|
||
Marker ID 1
|
0019
|
Marker ID 1
|
0019
|
Marker ID 2
|
0019
|
Marker ID 2
|
0019
|
Model ID 1
|
00000001
|
Model ID 1
|
00000001
|
Model ID 2
|
00000001
|
Model ID 2
|
00000001
|
Model ID 3
|
00000001
|
Model ID 3
|
00000001
|
ROM ver:
|
00010500
|
ROM ver
|
00010404
|
8. When the firmware copy is completed, the following screen will appear. Follow the instructions on the screen
SD Download Complete
Please Follow these instructions
- Remove the SD card from the back of the TV set.
- Disconnect the Power Cable from the wall socket.
- Re-connect the power cable to wall socket.
9. At this point, firmware upgrade to your unit has been completed.
10. Run "Auto Scan" to re-program the channels on the unit. If the
channels are not re-programmed after the firmware upgrade, the unit
might not capture a channel correctly.