Philips MCM279 DVD Mini Hi-Fi system – How to disassemble – Circuit Diagram
AMPLIFIEROutput power ................................................ 30 W RMS
Signal-to-noise ratio ....................................... ≥ 65 dBA
Frequency response ............. 100 – 18kHz, ± 3 dB
Input sensitivity AUX ....................... 0.5 V (max. 1 V)
Impedance loudspeakers ..................................... 6Ohms
Impedance headphones .................... 32 Ohm -1000 Ohm
LIQUID LENS CLEANING
Before touching the lens it is advised to clean the surface of the
lens by blowing clean air over it. This to avoid those little particles
makes scratches on the lens.
Because the material of the lens is synthetic and coated with a
special anti-reflectivity layer, cleaning must be done with a
non-aggressive cleaning fluid. It is advised to use “Cleaning Solvent
B4-No2”, available with code number 4822 389 10026.
The actuator is a very precise mechanical component and may not be
damaged in order to guarantee its full function. Clean the lens gently
(don’t press too hard) with a soft and clean cotton bud moistened with
the special lens cleaner.
Circuit diagram.
Main board: Used ICs - ET2314 – D9258 – SAA7824HL – KH29LV800CTTC-70G – SCF5250AG100 - ET8862Q – SAA658B – AT24C02 – HEF4094BT
Power amplifier circuit
Used ICs: TDA8932BT
– AZ34063AM
Disassemble procedure
A. Remove stand. Release click and pull it out.
B. Remove Top Cabinet. Remove screws MP 3x10 - 6 pcs.
C. Remove Amplifier board.
C1: Remove screws 2 pcs.
C2: Remove screws 2 pcs.
D.
Remove Main board
D1: Remove screws MP 3x10 - 3 pcs.
D1: Remove screws MP 3x10 - 3 pcs.
D2:Remove
screws MP 3x10 - 3 pcs.
Then
remove lens frame cosmetic top-right&left.
E.
Remove Key board
E1: Remove screws MP 2x8 - 8 pcs.
E1: Remove screws MP 2x8 - 8 pcs.
Then
remove lens frame cosmetic bottom-right&left.
Exploded view - parts list
Click on the pictures to zoom in