SCHNEIDER - 30M901 PAL-SECAM-NTSC SERVICE MODE - SOFTWARE UPDATE PROCESS
TO ENTER SERVICE MODE [FACTORY MODE]
- Set language to English.
- Press "i" key.
- Enter {6 => 4 => 0 => 5}.
- Press [1] and [2] key to see the Service Menu.
- Press 'Exit" key to Exit Service Mode.
Analogue Menu
METHOD TO ENTER SERVICE MENU TO DIGITAL BOARD
- Press "0" key
- Enter {6 => 4 => 0 => 5}
- Press 1, 2 and 3 key to see service menu.
- Press "Exit" to exit.
Digital Menu
With different software versions, the factory menu may be different.
SOFTWARE UPGRADE.
NEEDS
- Computer with Monitor.
- Data Cable.
- Special converter.
- Special loading board
Loading procedure to Analogue board.
- Copy the updated software to the computer.
- Remove tuner from LCD set.
- Switch ON the set and set to PC mode.
- Connect the TV and PC via 'Data Cable', one end with a switch to tuner port of TV set and the other end to the converter, which connected to the 'Printer Port' of the PC.
5. Run updated software [double click the software icon]. Will get a screen like this at the computer monitor.
6. Turn ON the switch on the board of the data cable.
7. Press any key on the computer keyboard, and then turn OFF the switch on the board of the Data Cable immediately.
8. The software begins to load. During loading, pay attention to
the loading schedule indicator on the screen. Until about '5' lines of
indication dots on the screen, the loading is complete {different
software may cause different indication dots}. The content of the last
page of the software will appear on the screen. The check the last 4
lines content, they can't be all be FF. That's it.
LOADING PROCEDURE TO DIGITAL BOARD
- Remove tuner, put the loading board on the tuner's position and keep the switch SW2 on the loading board on.
- Switch the TV On, and keep it in Standby Mode.
- Press SW3 on the loading board. The Green LED will flicker. It means that the software is being loaded.
- When the Green LED stops flickering, the loading is complete.
- Switch TV set OFF. Remove the board.
AFTER LOADING
- Set language to English.
- Press keys of "i", 6,4,0,5 to enter the Factory Menu of analogue board.
- Select item of "e2prom ID reset" and press "-->" key to set status of "Off" to 'ON'.
- Press [0] key to set the 'e2prom reset' active until the status 'On' turn to 'Off'.
- Quit the menu.
- Press "i" to enter "user menu" and select "reset" item by "up | Down" keys.
- Press "-->" key, two times, to act "reset" until an indicated "reset -- ok"
- Quit analogue user menu.
- Press keys of "0, 6, 4, 0, 5" and "1" to enter "e2prom reset sub-Factory Menu" of Digital board.
- Select item "RST" and press " --> " key to act the 'reset' on and OSD of "waiting......" appears.
- The set will turn Off automatically when finish of resetting
