Black Berry Tour 9630 – Disassembling procedure – How to remove the case – How to remove the Key board – How to remove the LCD
Flip
phone over so the back side is facing up.
Push
up on the center silver button to release the back cover.
Remove
the back cover.
Grip
the battery where the light grey half circles are located and pull up on the
battery. Remove the battery.
If
there is an SD card, press gently on the card and slide up to remove. If there
is a SIM card, press gently on the card and slide left to remove.
Use
the T6 Torx screwdriver to remove the four 8.00mm screws from the back of the
phone.
Using
the large blue plastic opening tool, pry the top plastic covering off.
There
is glue holding the top plastic covering. Additional pressure may be needed.
Use
the T6 Torx screwdriver to remove the two 8.00mm screws from the top of the
phone.
Remove
the back casing by wiggling it open.
Using
the small plastic opening tool, pry up the pop ribbon cable from the
motherboard.
Using
the small plastic opening tool, remove the side antenna cable.
Gently
push up on the keyboard and snap the front cover off.
Once
you remove the front cover, the keypad and trackball will be loose.
Remove
the keypad.
Gently
lift the motherboard to expose several ribbon cables.
Use
the small plastic opening tool to disconnect the orange LCD ribbon from the
square end of the ribbon cables.
Flip
the phone over. Using the large plastic opening tool, pry the LCD screen from
the motherboard.
Replace
the LCD screen
The LCD screen is held in place with glue.
The LCD screen is held in place with glue.