Samsung Galaxy Note 5 – Disassembling procedure – How to remove display
Remove SIM card tray at first. It's Samsung Galaxy Note 5 Duos, so
there are two slots.
Remove S pen.
Heat the back cover and cut it sticker underneath. Really strong
adhesive. Please be careful with the glass and edged back cover.
Remove the back cover. And the white strip is adhesive sticker.
Twist off all 20 screws together.
Push the front assembly out from middle housing. There are a
little black adhesive sticker on every corners.
Release battery connector from motherboard and pry the battery up.
Yes, there is also some adhesive underneath.
Remove two pieces of signal flex cables. And different versions
Samsung Galaxy Note 5 may have only one piece signal cable.
Release LCD connector, digitizer connector, earpiece assembly
connector, home button connector on the motherboard.
Release USB board connector on the back and remove the whole
motherboard.
Remove the rear camera. There is a black plastic bracket around
camera. So we have to remove them together. And there is a little adhesive
underlying.
Remove front camera and noise-canceling mic.
Remove motor vibrator easily.
Remove earpiece speaker assembly.
That's Samsung Galaxy Note 5 earpiece assembly. It's integrated by
speaker and sensors.
Now try to separate LCD screen from frame. The difficulty and risk
to remove screen alone are getting nearly 5 stars (5 scores all
together)respectively. The screen is weak and the adhesive are strong as well
too much.
Since Samsung applied the design that the USB board come with soft
keys together, DIY replace
USB board and LCD screen alone become much more difficult.
Be careful with the soft sensor keys on the bottom especially the flex.
In fact, the replacement of Samsung Galaxy Note 5 LCD screen, USB board or home button nearly the same with that teardown.
Be careful with the soft sensor keys on the bottom especially the flex.
In fact, the replacement of Samsung Galaxy Note 5 LCD screen, USB board or home button nearly the same with that teardown.
Loosen two soft sensor keys from frame carefully. And remove the
last securing screw on USB board.
Remove the USB board finally.
Could you see the mark on the right of the home button? Push the
button as its direction and can loosen it from securing slot easily. And then
cut the adhesive sticker under the flex.
Remove home button flex. Though it's a small component, it's
really complicated and difficult to replace, even at the risk to break the
screen.
