LG Chocolate 3 – Disassembling procedure – How to remove the case – How to remove the keypad – How to remove the motherboard
LG Chocolate 3
Turn the phone off before
starting the replacement process.
Place the phone face down.
Press your finger down on the indentation and slide the back plate off.
Place the phone face down.
Press your finger down on the indentation and slide the back plate off.
Using your index finger lift and
remove the battery from the phone.
Use the pointed end of the
spudger to pull out the plastic inserts that are located on the left and
right-hand corners.
If needed, use the tip of a push
pin instead of the spudger to remove the plastic inserts.
Using a Phillips #00 screwdriver,
remove the six 3mm long screws found along the edges of the phone.
If needed, use tweezers to remove
loose screws from the recessed holes.
Screws are small, therefore, they should be placed in a secure location to prevent misplacement.
Screws are small, therefore, they should be placed in a secure location to prevent misplacement.
Pull the rear case up using the
spudger.
The rear case is connected to the
right side of the phone via red and blue cables, be careful not to pull these
cables out.
The volume control buttons on the side might fall out of their sockets. Carefully replace them with a pair of tweezers before you reassemble the rear case.
The volume control buttons on the side might fall out of their sockets. Carefully replace them with a pair of tweezers before you reassemble the rear case.
Use tweezers to pull the clear
end of the red and blue speaker cables away from motherboard.
Carefully remove the rear case
from the phone.
Use tweezers to remove the music
button found on the side of the phone.
Use tweezers to remove the volume
control buttons on the opposite side of the phone.
Use the flat end of the spudger
to lift the orange display data cable.
Carefully insert the plastic
opening tool between the motherboard and the back of the phone.
Use your thumb and index finger
to carefully lift and separate the motherboard from the back of the phone.
Be cautious of the orange display
data cable, it may stick to the motherboard.
To avoid this, lift the data cable away from the motherboard before removal.
To avoid this, lift the data cable away from the motherboard before removal.
Open the phone.
Keep the phone open by keeping a
firm grip on the hinges to avoid any damages to the phone.
Lift the orange data cable up so
that it is elevated.
Gently use a finger to lift the keypad out.
Gently use a finger to lift the keypad out.
Insert the spudger in between the
keypad and the phone.
Lift the keypad to seperate it
from the phone.
Remove the damaged keypad.
Insert the replacement keypad.
Reassemble the phone after the broken keypad is replaced.
Reassemble the phone after the broken keypad is replaced.
