SONY KDL-40XBR4 - KDL-46XBR5 - SELF CHECK MODE- INVERTER REPLACEMENT - KDL-40XBR4 - KDL-46XBR5
KDL-40XBR4 -
KDL-46XBR5 - KDL-40XBR5 - KDL-46XBR4 (Remote control RM-YD017)
Description
of LED Indicators.
POWER LED
> Green LED > Light when the TV set is on.
STANDBY LED
> Red LED > Lights up in red when TV is in PC standby mode. If LED blinks
continuously, this may indicate that the TV needs servicing.
PIC OFF/TIMER
LED > Green or Orange LED > Lights
up in green when Picture Off is activated. Lights up in orange when the timer is set When
timer is set, the LED remains lit even when the TV is turned off.
SELF
DIAGNOSTIC FUNCTION
The units in
this manual contain a self-diagnostic function. If an error occurs, the STANDBY
LED automatically begins to flash. The number of times the LED fl ashes
translates to a probable source of the problem. A definition of the STANDBY LED
flash indicators is listed in the instruction manual for the user’s knowledge
and reference. If an error symptom is difficult to reproduce use the Remote
Commander to display the record that is stored at the internal NVM to specify
the cause.
{One flash
is not used for self-diagnosis}
Diagnostic
Indicators
When an
error occurs, the STANDBY LED flashes a set number of times to indicate the
possible cause of the problem. If there is more than one error, the LED will
identify the first of the problem areas. If the errors occur simultaneously,
the one that corresponds to the fewest fl ashes is identified first. (Results
for all of the following diagnostic items are displayed on screen. No error has
occurred if the screen displays a “00”)
TV must be
in standby mode. (Power off).
Press the
following buttons on the Remote Commander within a second of each other:
DISPLAY >
CHANNEL-5 > VOLUME (--) > TV POWER.
The Self Check list displays. Information
Indicator displays time of last 3 events (Not used in FIX2 models).
Resetting
the Diagnostic Indicators
After
completing the repair of the set, reset the Self Check screen to set all the
display results to “00”.
* TV must be
in standby mode. (Power off).
* Press Display
> Channel-5 > Volume (--) > TV Power
* Press Channel
‘8’ > then press channel ‘0’. To
EXIT, press TV Power.
REPLACING
THE INVERTER CONNECTOR ASSEMBLY
1. After
inserting the connector into the Inverter board, push the middle section of the
inverter connector to lock on the terminal.
2. Push the
right section of the inverter connector and confirm it is securely connected.
3. Push the
left section of the inverter connector and confirm it is securely connected.
