Technical description and composition of the IZUMI TLE24IF600B TV, type of panel and applicable modules. The composition of the modules.IZUMI LED
Model: TLE24IF600B
Chassis / Version: MSTV59XUS-V1.0
Panel: M240HW02 V.1
LED driver (backlight): HQ-LED72 REV2.0 HQ-LED72A8
Power Supply (PSU): AY036P-1HF03 AY1231A057699
MainBoard: MSTV59XUS-V1.0
IC MainBoard: CPU: TSUMV59XES-Z1, Flash: cFeon Q32B-104HIP
Tuner: CDT-3BP512-36
Technical Specifications TLE24IF600B
IZUMI TLE24IF600B
General repair guidelines for TV LCD LED
Repair of electronic devices, including the IZUMI TLE24IF600B TV, it is advisable to start with an external examination of its external and internal elements. Often, by the external signs and nature of the damage to the elements, it becomes possible to draw some conclusions and determine a further algorithm for finding a defect before making the necessary measurements at control points. Carbonized paint on the upper layer of resistors, electrolytic capacitors of rectifier filters swollen after boiling, cracked soldering at the terminals of heating elements or transformers can often suggest the cause of the defect and possible consequences.
If the IZUMI TLE24IF600B does not turn on, no control lights on the front panel light up or blink, therefore, there is a very high probability of a power module malfunction. In some cases, only the processor power regulator may be faulty. It is advisable to start the troubleshooting of the power supply module by checking the state of the electrolytic capacitors of the rectifier filters and the mains fuse. Defective capacitors should be replaced. If the mains fuse is broken, it is necessary to check first of all the power semiconductor elements - rectifier diodes and transistors, which are often found in such a state of breakdown.
The reasons for the breakdown of the power switch in pulsed power supplies (IIPS) can be different, for example, a malfunction of semiconductor cells or electrolytic capacitors in the stabilization circuits of the primary circuit, as well as a failure in the operation of the PWM controller chip or broken resistors in its bundle.
If the IZUMI TLE24IF600B does not have an image, but there is sound and the TV is controlled by the remote control, a malfunction in the backlight circuits of the M240HW02V.1 panel is likely. The LEDs or the power converter - LED driver may be faulty. Often in such cases, when you turn on the TV, an image appears and immediately disappears. First of all, it is necessary to verify the operability of the electrolytic capacitors of the rectifier filter supplying the LED driver, and check the LEDs, connecting obviously known good diagnostics.
To check the health of the LEDs, as well as contact connections in the ruler circuit, it is necessary to disassemble the panel.
It is impossible to detect a break in the LED line without disassembling the panel with a simple multimeter. The LEDs are connected in series and to open their transitions, a voltage of several tens of volts is required. Ideally, a current source is suitable for such purposes.
Diagnostics and repair of the MSTV59XUS-V1.0 motherboard is carried out by checking the performance of the stabilizers or power converters of the module chips. In some cases, a software update is required.
In cases of complex repairs of MB (SSB) and in the presence of the necessary skills and equipment, sometimes it may be necessary to replace its CPU chips: TSUMV59XES-Z1, Flash: cFeon Q32B-104HIP and other possible faulty components. Malfunctions associated with the application of BGA soldering technologies are usually easily diagnosed by the heating method.
Before changing the tuner CDT-3BP512-36, if it is not possible to tune to television channels, make sure that there are supply voltages, including varicap power supply (30-33V), which must be measured on the corresponding tuner pins.
Attention! Users and owners of TLE24IF600B televisions who do not have the appropriate qualifications, knowledge and experience are strongly advised against self-repair attempts in order to avoid negative consequences that could lead to complete non-repairability of the device.
FIRMWARE FOR SPI FLASH -----------> IZUMI TLE24IF600B, Main: MSTV59XUS-V1.0, Panel: M240HW02V.1
The appearance of the MainBoard MSTV59XUS-V1.0 is shown in the figure below:MSTV59XUS-V1.0
The appearance of the power supply
Main features of the IZUMI TLE24IF600B device:
Installed matrix (LED-panel) M240HW02 V.1.
The LED driver HQ-LED72 is used to power the backlight LEDs.
The formation of the necessary supply voltages for all nodes of the IZUMI TLE24IF600B TV is carried out by the power module AY036P-1HF03, or its analogs.
MainBoard - the main board (motherboard) is an MSTV59XUS-V1.0 module, using CPU chips: TSUMV59XES-Z1, Flash: cFeon Q32B-104HIP and others.
The tuner CDT-3BP512-36 provides the reception of television programs and tuning to channels.
Additional technical information about the panel:
Brand: AUO
Model: M240HW02 V1
Type: a-Si TFT-LCD, Panel
Diagonal size: 24.0 inch
Resolution: 1920x1080, FHD
Display Mode: MVA, Normally Black, Transmissive
Active Area: 531.36x298.89 mm
Surface: Antiglare, Hard coating (3H)
Brightness: 250 cd / m²
Contrast Ratio: 3000: 1
Display Colors: 16.7M (8-bit)
Response Time: 16/9 (Tr / Td)
Frequency: 60Hz
Lamp Type: 15S4P WLED Without Driver
Signal Interface: LVDS (2 ch, 8-bit), 30 pins
Voltage: 5.0V
