CHECKING THE SOFTWARE VERSION.
- With the TV on enter the Factory menu
- In the Factory menu, check if the software version installed is correct.
Main SW update via the User Menu
- Download the compressed file update.zip, change the name and extension to “V8-N563T01-LF1Vxxx.bin” where xxx is the version number.
- Save the file to the root of a USB device.
- Connect the USB device, with the software, to the USB port.
- Select MENU Support Update. of ware via USB.
- The device will find the Vxxx software. Press “Update”
- The update will start. After approximately 4 minutes the TV will automatically restart.
- After restarting, perform the reset by going to the settings menu “MENU (key) System Restore Mode
Factory. Confirmation and password request is requested. Enter 1234 and press "OK".
- After this the TV will restart.
Note: The version of the So ware to be used must be the one informed in the material plan of the respective product.
After approximately 4 minutes the TV will automatically restart.
UPDATE WHEN THE APPLIANCE HAS NO VIDEO
- Save the file to the root of a USB device by renaming it as “update.zip”.
- With the device disconnected from the mains, connect the USB device, with the installation software, to the USB port.
- Press the TV's Power key and keeping it pressed, connect the TV to the mains
- The update will start. After approximately 4 minutes the TV will automatically restart.
- After restarting, perform the reset by going to the settings menu “MENU (key) System Restore Mode
Factory. Confirmation and password request is requested. Enter 1234 and press "OK".
- After this the TV will restart.
PROJECT ID CHANGE
(If panel information is wrong)
If the screen is completely dark due to the difference in panel x installed ware, press 062598 + MENU + xxx (xxx: Panel ID)
After the update, the TV will enter TV mode and the channel that was previously selected. Enter the menu factory settings again, select option 3 - Reset Shop, press enter.
After the reset, switch on the device using the power key.
PANEL TEST MODE (WARM-UP)
Recommended for analysis of panels (spots, dots, scratches, etc.).
Enter the Factory Menu as indicated before, turn on the "Factory hotkey" option and turn on the "WARM-UP" function.
A sequence of screens in different colors will be generated where it can be verified in more detail, possible failures the panel.
VERIFICATION OF AUTHENTICATION KEYS
In the same “WARM-UP” mode, a table with the main product information will be displayed in the corner bottom right.
In this table we have the project information:
We have the project ID, as shown in the table above and then the version of the software in use.
Below the information of the recorded keys (MID):
MAC (Mac Address) Without recording this key, it is not possible to connect to the internet network via ethernet (LAN);
DID (Device ID) Factory Control of the product; Already included in the main ware.
ESN (Ne lix) Without the recording of this key, it will not be possible to access the Ne lix services;
HDCP Without recording this key, high definition images from the HDMI inputs will not be reproduced;
HDCP2.0 Without the recording of this key, high definition images via wireless will not be reproduced;
IMPORTANT NOTE: If some of the keys are not recorded, the information “NULL” will appear in substitution the respective key in that line as shown in the image on the right.
In this case, SEMP TCL support should be contacted for instructions on recording procedures.
To EXIT the “WARM-UP” mode, press the POWER key on the device because the control functions remote will be disabled and if the device is just disconnected from the network, the “WARM-UP” mode will return when connected to the network again.
After exiting WARM-UP, enter the factory menu again and turn off the Factory Hotkey option or give a user reset.
ENTRY STAGE
CONVERTING STEP
BACKLIGHT CONTROL STEP
AMP USING AD82587
PHONES OUTPUT - AMP AND CONNECTIONS
