HOW TO ENTER SERVICE MODE TO THOMSON TVs
Thomson Televisions - Service Mode Entry> Switch the set to standby, ad switch it OFF by its front panel ON/OFF switch.
> Press and Hold the 'Blue" button on the remote control, and switch ON the set by its front panel power ON/Off switch.
> To save the adjusted value in memory, and to exit from service mode, switch it OFF by its front panel power ON/OFF switch.
Before
entering service mode, be sure that the entire button on the remote control
will work properly, if anyone found inoperative, do not use it to enter the
service mode. If it is a universal
remote control; check it well. With most
universal remote controls, sometimes, all the button functions might not work
as it should be. If so, try to set it
with another set-up code said for your device, and then make sure about its
working. I strongly recommend you to use
the original remote control to enter service mode.
This
is because;
Suppose
you have to enter the service mode to adjust certain parameter. You
haven’t made sure that all the function
of the remote control will work properly with your set or not. After
entering the service mode, as you know,
limited buttons on the remote control will be active. For example, in
service mode, channel Up,
Channel Dn, Volume Up and Volume down, and the OK button, Power button
and
Numerical buttons are used to adjust the data parameter. After
adjusting all these parameters; you
have to come out from the service mode to Normal mode. Otherwise, you
can’t operate the set. Suppose, the service mode procedure tells you
that, you should press the Power button on the remote control to Power
Off the
set, to come out from service mode to normal mode. Power down the set
by its main power button
won’t make it to normal mode. If the
power button on the remote control does not work, how can we come out
from
service mode to normal mode? In fact,
you can’t come out of service mode.
The
most important thing to note is this.
Before you attempt to enter the service mode option, read and understand
all the instructions. Be sure that there
is enough detail to Exit from the service mode.
If it is not there, never enter the service mode. For some sets, there
will be no Exit option. To such sets,
Power it OFF by the main power switch will do the same. But you should make it sure by reading the
instructions.
For
your information, I’ve included some set-up codes too here, to check with your
universal remote control, if the present set-up do not work with all the
functions it supposed to be. Set-up a
universal remote control is a trial and error procedure. You might have to check with many set-up
codes, before you get a proper code to your remote control to work properly
with your set. The included codes are
the common codes works for your brand.
Universal Remote Control Set-up Codes
0008 0024 0026
0049 0064 0074 0101 0134 0152 0165 0181 0182 0186 0196 0218 0230 0233 0237 0321
0424 0436 0462 0603 0604 0827
