LGP4247H-12LPB - EAY62512701- EAX64310401 - LED TV Power
LG 47LM5800-
LG 47LS5700 - LG 47LM6200 LED LCD TV Power Supply Regulator (SMPS) Circuit Diagram
Used
semiconductors: HS01G – STR A6059H – L6599AD - STF13NM60N (FET)
Firmware Version 1.00a. Checksum 0x2214
On
Condition:
In a moment of Power ON Signal activated, the current of 3.5V output
should be limited within 40mA (Max) at LCD TV condition for stability. Do not turn “Power ON” Signal on at the load
condition of 3.5V output, more than 40mA.
Total
regulation for each output circuit includes the results of input voltage
variation, load variation, warm-up drift and temperature change.
Ripple
and noise are measured at the end of output cable which are added a 0.1uF
ceramic capacitor and 47uF electrolytic capacitor. (Connected parallel).
SMPS SCHEMATIC
PWB
CONNECTOR VOLTAGES
Dielectric
Strength Voltage
AC
3KV or DC 4240V 1Min 10mA (Test SPEC )
AC 3.6KV 1 SEC 10 mA.(PSU Mass Production)
Between Primary and All Secondary Circuits.
AC 3.6KV 1 SEC 10 mA.(PSU Mass Production)
Between Primary and All Secondary Circuits.
Insulation
Resistance: Insulation resistance shall be more than 8M ohm (at DC 500V)
Between Primary Live, Neutral line and Secondary.
Burn-in
More
than 2 hours at 40℃
(±5℃),
Normal input voltage.
AC
on/off must be test 1 time after burn-in. 80% Load (except LED String current:
105mA) of specification.
Short
circuit protection between different output terminals is not considered.
Trip
point for over voltage indicates the operating point when the output voltage
slowly increases.