Nextbook NX008HD8G – How to replace the battery
Nextbook NX008HD8G: BATTERY REPLACEMENT PROCEDURE
How
to remove Back Panel
Using
your finger, open the plastic tab to the right of the rear-facing camera.
Wedge
your fingernail in between the back panel and the plastic tab and pull the
plastic tab towards your body.
Using
your finger, remove the SD card by pressing down on top of it (toward the
bottom of the device) until you hear a clicking sound.
Once
the card pops out, use your finger to pull the card completely out of the SD
card slot.
Remove
the 5 mm screw using the Phillips PH00 bit in the iFixit metal Screwdriver.
Use
the plastic opening tool to separate the back panel by carefully sliding the
narrow end of the tool between the front glass and back panel.
Use
a second plastic opening tool to help pry the front glass from the back panel.
You will hear some cracking sounds when separating the front glass from the back panel.The back panel latches releasing the front glass.
You will hear some cracking sounds when separating the front glass from the back panel.The back panel latches releasing the front glass.
Use
your hands to completely separate the rest of the front glass from the back
panel.
Do
not to pull the device apart with too much force. If you do, you may break or
bend the back panel.
Removing
Battery
Remove
yellow tape with a black edge that covers the red, white and black wires.
The yellow tape with a black edge is safe to remove completely.
The yellow tape with a black edge is safe to remove completely.
Remove
the white masking tape covering the red white and black wires.
Desolder
the red, white and black wires on the left side of the motherboard.
Use
the flat end of the spudger to carefully separate the smaller, silver battery
square from the digitizer.
The
battery is very malleable; do not try to take it all off at once.
Use
the flat end of the spudger to carefully separate the large battery from the
digitizer.
The
battery is very malleable; do not try to take it all off at once.