FIRMWARE UPDATE - TOSHIBA 32AV554/5D - 37AV554/5D - 42AV554/5D LCD TV [France]
# No picture under the weak electric field of DVB-T
# Block noise appears or No receiving the Signal under the
multi pass setting.
Corrective action; Firmware upgrading through interface PCB
(FWA1209)
Firmware is subject to the model as below.
As for 32AV555D, to check the panel information, enter the
service mode. And then, press the
button on the remote controller in sequence of “9” and “9”.
Confirm if Panel is SHARP or LPL on Version check mode as
shown figure.
Firmware updating procedure
NOTE: PERSONAL AND CUSTOM PREFERENCES WILL BE LOST UPON COMPLETSION
OF THIS FIRMWARE UPDATE. PLESE MAKE NOTE OF ANY PREFERENCE SETTINGS PRIOR TO STARING THIS FIRMWARE
UPDATE.
1. Plug in AC connector and Turn “ON” the TV.
2. Unplug the AC connector while TV is “ON”.
3. A socket for Interface PC Board is located at the left side
of HDMI Terminal on the back of the TV. Open the lid covering the socket as
shown figure.
4. Connect the USB memory to the Interface PC Board, and insert
the Board to the socket.
5. Plug in AC connector to begin the Firmware upgrade.
6. A status bar will be displayed as shown Figure.
7. Upon completion, unplug the AC connector.
8. Pull out the Interface PC board from the Socket, and
close the lid.
9. Plug in AC connector.
10. Writing of Ship out Data (ex-factory data for each
Destination) starts automatically as shown figure.
Below is an example of a European Continental version.
11. Upon completion, “OK” is displayed as shown.
12. Unplug the AC connecter and the plug in SC connecter.
13. Press “Menu” button on the remote controller.
Via UP/DOWN keys on the remote controller, select
è “Set up”
è “Reset TV”
Note; “Reset TV”
function may not be visible until you select it through “Set up” menu.
14. Press the “Enter” button on the remote controller.
15. Use the right allow keys to select “Yes” and press”
Enter” on the remote controller to reset the TV.
16. TV will reboot automatically and afterwards the Quick
Setup Screen will be displayed. Follow the instructions on the screen and
consult the owner’s manual for initial setup Setting.
17. To check the firmware version, press the “Menu” button
on the remote controller and go “Set up” and “system information” in sequence.
18. Confirm if version is Ver T64.344 on system information.
