SAMSUNG
Model: LE32B653T5W
Chassis / Version: N68A
Panel: T315HW02
Inverter (backlight): integrated into PSU
PWM Inverter: SEM2006
MOSFET Inverter: 4N50
Trans Inverter: FLT-HU32
Power Supply (PSU): BN44-00261A
PWM Power: FAN7530 (PFC), STR-W6252
MOSFET Power: 6N60
MainBoard: BN41-01167C
IC MainBoard: WM8593SEF-T, STA339BW, TEA6425D, K4T1G164QE-HCE7
Tuner: BN40-00145A TDHG6-K12A
Technical Specifications LE32B653
SAMSUNG LE32B653T5W
General repair guidelines for TV LCD
Possible manifestations of defects
- The SAMSUNG LE32B653T5W TV does not turn on and does not show any signs of operability. There is no reaction to the remote control and control buttons from the front panel.
With such manifestations, a malfunction is most likely to be detected in the BN44-00261A power module. It is necessary to measure the output voltage, and in case of their absence, check the serviceability of the power switches (6N60) of the converters and rectifier diodes for possible breakdown (short circuit).
In case of breakdowns in the secondary circuits, the converter can emergencyly operate in the short circuit mode, and during short circuit in the power elements of the primary circuit, the mains fuse usually breaks. The health of the PFC node can be indirectly judged by the presence of an increased voltage (380-400V) on the filter of the network rectifier.
Mos-Fet keys used in switching power supplies usually fail due to a malfunction of other elements that can put it out of operation in key mode or provoke an excess of the maximum current or voltage. It can be supply, damper circuits, or elements of OOS (negative feedback) stabilization. The reason for the breakdown of the power switch may be PWM (PWM) FAN7530 (PFC), which is checked by replacing a known-good one.
- There is no image, there is sound, it reacts to the remote control, channels are switched. In some cases, the image appears when you turn on and immediately disappears.
The defect can be caused by problems in the nodes or elements of the backlight of the display, or in the power supply of the lamps or inverter. If all the electrolytic capacitors of the filter for the power supply of the inverter are working, make sure that the lamps are working, then you need to check the converter keys and the secondary windings of the transformers.
If in diagnosing a malfunction, it is necessary to disable the inverter protection, there is a risk of failure of the power elements of the inverter, and special care is required during operations, and after their completion, it is necessary to restore the protection circuits for further safe operation of the TV by the owner in normal mode.
- The TV does not turn on, the indicator signals standby or working mode, or blinks.
Repair or diagnostics of the BN41-01167C motherboard should begin by checking the stabilizers and power converters needed to power the chips and matrix. If necessary, you should update or replace the software (software). Sometimes it is necessary to check or replace (if necessary) the elements of the MainBoard board - WM8593SEF-T, STA339BW, TEA6425D, K4T1G164QE-HCE7. In cases where the BGA processor is used, its malfunction is usually detected by local heating.
Before replacing the tuner BN40-00145A TDHG6-K12A, if there is no tuning for the channels, you must first check the software and the supply voltage at its terminals. It is also necessary to make sure that the tuner and processor can exchange data via the I2C bus
TV users and owners need to remember that attempts to self-repair a SAMSUNG LE32B653T5W TV without the appropriate qualifications and necessary experience can lead to serious negative consequences!
SCHEMATICS: Samsung LE32B550 Chassis N68A.
FOR MODELS: LE32B55*, LE37B55*, LE40B55*, LE46B55*, LE32B65*, LE37B65*, LE40B65*, LE46B65*, LE55B65*, LE32B57*, LE37B57*, LE40B57*, LE46B57*, LE32B67*, LE37B67*, LE40B67*, LE46B67*, LE55B67*, LE40B62*, LE46B62*, LE52B62*, LE40B75*, LE46B75*, LE52B75*.
PSU SCHEMATICS Samsung BN44-00261A Power supply.
The appearance of the MainBoard BN41-01167C is shown in the figure below:
BN41-01167C
BN41-01167C can be used in TVs:
SAMSUNG LE32B550A5 (Panel LTF320HA09), SAMSUNG LE32B653T5W (Panel T315HW02), SAMSUNG LE32B652T4W (Panel T315HW02 V.3), SAMSUNG LE37B653T5W LE37B653 (Panel T370HW02 V.E).
The appearance of the power supply
Main features of the SAMSUNG LE32B653T5W device:
Installed matrix (LCD panel) T315HW02.
To power the backlight, a converter is used, combined with a power supply, controlled by a PWM controller SEM2006. The transformer FLT-HU32 is installed in the inverter converter. As power elements of the inverter, keys of type 4N50 are used.
The necessary supply voltages for all nodes of the SAMSUNG LE32B653T5W TV are generated by the BN44-00261A power module or its analogs using FAN7530 (PFC), STR-W6252 microcircuits and 6N60 type power switches.
MainBoard - the main board (motherboard) is a module BN41-01167C, using microcircuits WM8593SEF-T, STA339BW, TEA6425D, K4T1G164QE-HCE7 and others.
The tuner BN40-00145A TDHG6-K12A provides the reception of television programs and tuning to channels.
Additional technical information about the panel:
Brand: AUO
Model: T315HW02 V0 CELL
Type: a-Si TFT-LCD, CELL
Diagonal size: 31.5 inch
Resolution: 1920x1080, FHD
Display Mode: AMVA3, Normally Black, Transmissive
Active Area: 698.4x392.85 mm
Surface: Antiglare (Haze 11%), Hard coating (3H)
Glass Depth: 0.70 + 0.70 mm
Transmissivity: 4.0% (with Polarizer)
Contrast Ratio: 4000: 1
Display Colors: 16.7M (8-bit), CIE1931 72%
Response Time: 6.5 (G to G)
Frequency: 60Hz
Signal Interface: LVDS (2 ch, 8-bit), 51 pins
Voltage: 12.0V