ELENBERG LED
Model: 32DH5130
Chassis / Version: TP.MS338.PB801
Panel: MLTY315A082
LED driver (backlight): integrated into MainBoard
Power Supply (PSU): integrated into MainBoard
PWM Power: PWM SOT23-6
MainBoard: TP.MS338.PB801
IC MainBoard: KLM4G1FEPD-B031, 25X10, MSH6110A, MSB102KT A7MNH53ZA
Tuner: NoName
Appearance
ELENBERG 32DH5130
General repair guidelines for TV LCD LED
Possible malfunctions
- The ELENBERG 32DH5130 TV does not turn on at all. There is no reaction to the remote control and control buttons from the front panel. Indicator lights do not light or flash.
In such cases, the AC / DC voltage converter, which is combined with the main board TP.MS338.PB801, is often faulty. It is necessary to measure its output voltages, and in case of their absence, check the operability of the power switches of the converters and rectifier diodes for the probability of short circuit.
In case of any breakdowns in the secondary circuits, the converter can operate in emergency short circuit mode, and during short circuit in the power elements of the primary circuit, the mains fuse or the current sensor at the source of the key more often breaks.
Breakdown of power switches (MosFet) in pulsed sources is sometimes caused by malfunctions of other circuit elements, for example, in circuits supplying a PWM controller, frequency-setting or damper ones, as well as in negative feedback circuits (OOS) of stabilization. PWM controllers (PWM) PWM SOT23-6, if they do not have visible damage to the case and open short circuit between the terminals, are usually checked by replacement.
- There is no image, there is sound, it is responding to the remote control. Or immediately after turning on for a second, the image may appear and immediately disappear.
The most likely in these cases is a malfunction of the LED backlight. The reason can be both in the power supply of the LEDs, in their serviceability (breakdown or breakage), as well as in the violation of the contact connections of the LED strips.
To detect a break in the LED lines without disassembling the panel, a current source is required. It is impossible to open transitions connected in series with a simple multimeter; voltage of several tens of volts is necessary.
- The TV does not enter the operating mode, does not respond to the remote control. The indicator on the front panel lights constantly or blinks.
Repair or diagnostics of the TP.MS338.PB801 motherboard should begin by checking the stabilizers and power converters needed to power the chips and matrix. If necessary, update or replace the software (software). Board repair and replacement of KLM4G1FEPD-B031, 25X10, MSH6110A, MSB102KT A7MNH53ZA microcircuits are carried out with the necessary equipment and the corresponding element base. Faults associated with the application of BGA processor soldering technologies can be localized by the heating method.
If the TV works normally from external devices, but does not tune into television channels, the NoName tuner may be malfunctioning. In such cases, first of all, you should make sure that there are supply voltages at its corresponding conclusions. It is also necessary to make sure that the tuner and processor can exchange data via the I2C bus. Sometimes the cause of the inoperability of the tuner may be a software failure.
Once again, we remind TV users: you should not make attempts to repair it yourself without the appropriate knowledge, experience and the necessary qualifications! Entrust repair to professionals with sufficient experience in the field of repair of electronic equipment.Repair MainBoard
The appearance of MainBoard TP.MS338.PB801 is shown in the figure below:
TP.MS338.PB801
Main features of the ELENBERG 32DH5130 device:
Installed matrix (LED panel) MLTY315A082.
To power the backlight LEDs, a converter is used, combined with the main board TP.MS338.PB801.
The power module is combined with the MainBoard and is made according to the flyback AC / DC voltage converter circuit using PWM SOT23-6 microcircuits.
MainBoard - the main board (motherboard) is a module TP.MS338.PB801, using microchips KLM4G1FEPD-B031, 25X10, MSH6110A, MSB102KT A7MNH53ZA and others.
The NoName tuner provides television reception and channel tuning.