Philips BDP3200 Blu-ray Disc Player – how to upgrade the firmware – Disassembly – Troubleshooting - SMPS schematic
Philips
BDP3200 /05/12 Blu-ray Disc
Player Software Upgrades – disassembly – troubleshooting - Power Supply regulator circuit diagram
Software check and upgrade
Preparation to upgrade software
1) Start the CD burning software & create a folder named "UPG_ALL",
2) Then copy the Bin file (BDP3XXXXX-XXX-XXXXXX.bin) into it,
3) Burn the data onto the blank CD.
Procedure for software upgrade
Upgrade software via Disc
1) Power on the set and insert the prepared Upgrade CDR.
2) The set will starts reading disc & response with the following display TV screen:
Now searching for upgrade software!
Please wait…!
3) Then screen will display :
Software upgrades for this player has been found! Do you want to upgrade?
Cancel Start
4) Press Right cursor button to choose "Start", then press <OK>;
5) The software will updagrde and screen will display as below:
Upgrade is ongoing, Please wait…
Please do not unplug or switch off the device.
6) Restart the set.
Update software via USB
Flash Drive:
1) Go to www.philips.com/support to check if the latest software version is available for this player.
2) Download the software onto a USB flash drive's root DIR named "UPG_ALL".
3) Insert the USB flash drive to the USB jack of the rear panel.
4) In the Home menu, select <Setup> <Advanced> <Software update> <USB>.
5) Then press OK
6) you'll see now searching for new software, please wait.......
7) Waiting, the you'll see "software for this player has been found ......"
8) Then select "Start" and press "OK"
9) then you'll see "upgrade is ongoing ......", wait until it ends.
10) Player will restart automatically or press "Restart now" to restart, after restarting the upgrade ends.
1) Go to www.philips.com/support to check if the latest software version is available for this player.
2) Download the software onto a USB flash drive's root DIR named "UPG_ALL".
3) Insert the USB flash drive to the USB jack of the rear panel.
4) In the Home menu, select <Setup> <Advanced> <Software update> <USB>.
5) Then press OK
6) you'll see now searching for new software, please wait.......
7) Waiting, the you'll see "software for this player has been found ......"
8) Then select "Start" and press "OK"
9) then you'll see "upgrade is ongoing ......", wait until it ends.
10) Player will restart automatically or press "Restart now" to restart, after restarting the upgrade ends.
Read out the software
versions to confirm upgrading
4) In homemenu,enter
"setup > advanced > version info", press
"OK"
an other information will
display on the TV screen as below:
Model:XXX.XXX
Versions
subinfo:xxxx
system SW:xxxx
ethernet MAC:xxxxxxxx
Caution: The set must not be power off during upgrading; otherwise the Main board will be damaged entirely.
> The instructions above
is only for MKII version of BDP3200 and set with Series No. starting from
GS2xxxxxxxxxx.
> BDP3200 not need alignment between Blu-ray Loader and Main Board, you can replace the defective loader or Main Board by new one directly.
> BDP3200 not need alignment between Blu-ray Loader and Main Board, you can replace the defective loader or Main Board by new one directly.
SMPS schematic & PWB
Click on the pictures to zoom