SAMSUNG - GY 15CS _ TFT-LCD MONITOR_Troubleshooting.
Before troubleshooting, setup the PC's display as below.
- Resolution: 1024x768.
- H-Frequency: 48KHz.
- V-Frequency: 60Hz.
If no picture appears, make sure Power Cord is connected correctly.
Check the following circuits.
- No raster appears: SMPS PCB, Main PCB.
- 12V develop but no screen: Main PCB.
- 12V does not develop: SMPS PCB.
Push and Hold 'EXIT' button for more than 5 seconds, the monitor will return to the factory reset.
TROUBLESHOOTING CHART.
NO POWER
When pin 5 of CN101 {Power On State} is 0V does proper DC
13V, DC3.3V appear at Pin 1,2 & 6,7 of CN101 separately?
|
No
|
Change IP board.
|
Yes
|
|
|
When Pin 1 of IC105 is DC 3.3V does proper DC 2.5V appear
at Pin 3 of IC105?
|
No
|
Check IC105 and related circuit.
|
Yes
|
|
|
When Pin 5 of IC 101 is IC 3.3V does proper 3.#V appear at
Pin 2,3 of IC 101?
|
No
|
Check IC101 and related circuit.
|
Yes
|
|
|
When Pin 1 of iC403 is DC 12V does proper DC5V appear at
Pin 3 of IC403?
|
No
|
Check IC403 and related parts.
|
NO VIDEO
Check the signal cable connection & power first.
Do X301 oscillate properly?
|
No
|
Replace or check related circuit.
|
Yes
|
|
|
Is R,G,B input at R215, R217 & R219?
|
No
|
Check input part.
|
Yes
|
|
|
Does Sync appear at Pin8 and 10 of IC201?
|
No
|
Check IC201 and related circuit.
|
Yes
|
|
|
Is there Sync and Data output: R303, R304, R301, R305
& RA301 ~ RA305, RA311?
|
No
|
Check the power related to IC301 and output part.
|
Yes
|
|
|
Does the output signal appear at R411 ~ 420?
|
No
|
Check LVDS_EN at R302 is high or not. {Normal state is High}
|
Yes
|
|
|
There are DC 3.3V at Pin 19, 20 of CN401?
|
No
|
Check the IC101 and related circuit.
|
Yes
|
|
|
Replace LCD Panel
WAVEFORMS
|
|
|