VIEWSONIC N2752W - HOW TO ENTER SERVICE MODE - PASSWORD RESET - V-Chip Unlock
How to enter Service Mode to Viewsonic N2752W-1 _ TFT-LCD TV
{To
enter the Service Mode (Factory Mode), you should have its remote
control} The original remote control number to this TV is - RC00070P
Universal Remote Control Set-up Codes.
Press POWER ->▲ and -> ENTER at the same
time, to go into the FACTORY MODE [Service Mode]
The factory default of the password is 0000.
To enable parental control, input the password, press ▼ button to focus on OK key, and press ENTER. (Select cancel if you want to exit)
To enable parental control, input the password, press ▼ button to focus on OK key, and press ENTER. (Select cancel if you want to exit)
CHANNEL LOCK
* To lock channels. Use ◄► to select the channel you want to lock,
and then press ENTER to lock or unlock it.
* Enter the new password, use ▼ to move the cursor down, and then
enter the new password again, press OK to confirm or Cancel to exit.
Note: Please make sure you remember your new password after changing. If the password is forgotten or missing, please use the remote control to enter 8866 to clean the password and reset a new one.
Clear All
Note: Please make sure you remember your new password after changing. If the password is forgotten or missing, please use the remote control to enter 8866 to clean the password and reset a new one.
Clear All
To clear all the locks set before, press ENTER.
V-VHIP FUNCTION
To set up V-CHIP function; Press V-CHIP button -> Enter the password -> press ENTER
Note: The factory default of the
password is 0000. If you have changed the password, make sure you
remember the new password, because you cannot recall the default setting of the
password by any selection.
To initialize the EEPROM [MEMORY RESET]
Select EEPROM INITIAL on the screen
display; and press ENTER.
The act of EEPROM INITIAL is completed when EEPROM
INIT disappeared.
The Universal Remote Control Set-up Codes to check with Viewsonic Brand TVs are: 0052 0073 0360
