LG DM19D - LG OK75 - MECHANISM DISASSEMBLE PROCEDURE
Cover Top
1) Remove
the 2 screws (S1).
2) Remove the Cover Top.
Clamp Assembly
1) Place the
Clamp Assembly as Figure
B.
2) Bending the Cover Top in direction
of arrow (2) as Figure B.
3) Separate the Clamp Assembly from
the
Cover Top.
Plate
1) Turn the
Plate to a counterclockwise direction
and then lift up the Plate.
2) Remove the Plate.
Magnet
Remove the
Magnet.
Clamp
Remove the
Clamp.
Tray Disc
1) Insert
and push a flat-head screwdriver in the Emergency eject hole (H1) at the right
side, so that the Tray Disc is ejected about 15 ~ 20 mm.
2) Pull the Tray Disc until it is
locked.
3) Grasp the both sides of the Tray Disc and lift it up as Figure D, and then pull the Tray Disc until it is separated from the MD Sub Assembly completely.
Pick Up Assembly
1) Detach
the Gasket Tape.
2) Disconnect the wires (BLK, RED,
BRN, ORN) from the Deck PCB Assembly by desoldering.
3) Remove the 4 screws (S2).
4) Disconnect the FFC Cable from the
Pick Up Assembly.
5) Remove the 4 Rubber Dampers.
Base Up-Down
Unlock the
Locking Tab (L2) in direction of arrow and then lift up the Base Up/Down to
separate it from the Base Main.
• When reassembling move
the Guide in direction of arrow (A) until it is positioned as Figure G-1.
• When reassembling insert the (B) portion of the Base Up/Down in the (C)
portion of the Guide as Figure G-2.
• When reassembling insert the (D) portion of the Base Up/Down in the Hole (H2)
of the Base Main as Figure G-3.
Belt Loading
Remove the
Belt Loading.
Gear Pulley
Unlock the
Locking Tab (L3) in direction of arrow and then separate the Gear Pulley from
the Base Main.
Gear Loading
Remove the
Gear Loading.
Guide
1) Move the
Guide in direction of arrow (A) as Figure H-1.
2) Separate the Guide from the Base
Main.
Deck PCB Assembly
1)
Disconnect the wires (RED, BK) form the Deck PCB Assembly by desoldering.
2) Remove the 1 screw (S3).
3) Separate the Deck PCB Assembly from
the Base Main.
Motor Assembly
Unlock the
Locking Tab (L4) in direction of
arrow and then separate the Motor
Assembly
from the Base Main.
FFC Cable
Remove the
FFC Cable.
DM19D Exploded view