Technical description and composition of the LG 43UJ655V TV, panel type and modules used. The composition of the modules.LG LED
Model: 43UJ655V
Chassis / Version: LJ7 Chassis
Panel: LC430DGG (FK) (M4) HC430DGN-ABSR2-211X
LED backlight: 43UJ65_UHD LG Innotek 17Y 43inch_A-Type
T-CON: HV430 / 550QUB-N40 47-6021117
LED driver (backlight): integrated into PSU
Power Supply (PSU): EAX67267601 (1.6) REV1.0 LGP43D-17U2
MainBoard: EAX67133404 (1.0)
IC MainBoard: Realtek K3Lp, FT24C256A, DTA2010M
Tuner: TDJN-G501D EBL61841001
Specifications 43UJ655V
LG 43UJ655V
General recommendations for TV LCD LED repair
Possible manifestations of malfunctions
- The LG 43UJ655V TV does not turn on and does not show any signs of turning on, does not respond to the control buttons and the remote control.
In such cases, the fault should be looked for primarily in the EAX67267601 power supply module. It is necessary to measure its secondary output voltages, and if they are absent, check the power switches and rectifier diodes in the converters for a short circuit.
In the event of diode breakdowns in the secondary circuits, the converter can operate in an emergency mode of short circuit without output voltages, and in the event of a short circuit in the power elements of the primary circuit, the mains fuse and / or the current sensor in the source of the key usually breaks off.
Breakdown of power switches (MosFet) in switching sources is sometimes caused by malfunctions of other circuit elements, for example, in the circuits supplying the PWM controller, frequency setting or damper, as well as in the circuits of Negative Feedback (OOS) stabilization. PWM controllers (PWM), if they do not have visible damage to the case and an outright short circuit between the terminals, are usually checked by replacement.
- There is no picture, but there is sound and reaction to commands from the remote control. Or the image appears immediately after switching on and disappears.
The most likely problem in these cases is a malfunction of the LED backlight. Most often, the reason for this is a break in the LEDs, or poor contact in the connectors of the brackets, less often the LED driver may be faulty.
To check the health of the LED circuit, it is better to use a current source with a maximum voltage of 200V. We do not recommend using any voltage sources for this purpose. You can check each LED separately with a simple Chinese multimeter (powered by 9 volts) in the P-N transition test mode. If you connect the red probe of the multimeter to the anode of the LED, and the black one to its cathode, then the 3-volt LED will light up slightly, and in the opposite direction you can detect the transition of the emergency zener diode. The serviceability of the PN junction of the Zener diode indirectly indicates the serviceability of the LED-a
- The indicator blinks or is on constantly, the TV does not turn on, does not respond to the remote control.
Repair or diagnostics of the EAX67133404 motherboard should begin with checking the stabilizers and power converters required to power the microcircuits and matrix. If necessary, you should update or replace the software (software). In cases of complex MB (SSB) repairs and with the necessary skills and equipment, it may sometimes be necessary to replace its Realtek K3Lp, FT24C256A, DTA2010M chips and other possible faulty components. Malfunctions associated with the use of BGA soldering technologies are usually easily diagnosed by the warm-up method.
If there is no tuning for terrestrial or cable TV channels, you should make sure that the software is correct, as well as that the supply voltages on the terminals of the TDJN-G501D EBL61841001 tuner match. It is also necessary to check with an oscilloscope the presence of pulses of data exchange between the tuner and the processor via the I2C bus.
If the LG 43UJ655V has no picture, but there is sound, often the LCD backlight LC430DGG (FK) (M4) HC430DGN-ABSR2-211X simply does not work. Moreover, in LED TVs, the LEDs inside the panel usually fail, less often the LED driver.
In such cases, you can see a barely noticeable image with a successful hit of external light on the screen.
Replacing the LEDs requires disassembling the LC430DGG LCD panel, a process that requires experience and qualifications from the technician. We do not recommend doing such work on your own to the owners of TVs and craftsmen who do not have experience in repairing LCD panels
If there is no image, and the backlight is on, the screen becomes slightly lighter when turned on, and in an open TV you can see the light through the holes in the panel case.
In this case, the panel may also be faulty - damage to the strips, loops, for example, as a result of moisture ingress after unsuccessful washing of the screen, the T-CON (Timing Controller) board may be faulty. But often the main board MainBoard EAX67133404 turns out to be faulty, a software failure is also possible.
Then, first of all, it is necessary to check the panel supply voltage, the fuses on the T-CON board, as well as the supply and reference voltages of the column and line drivers - VGH, VGL, Vcom.
If these measurements are within the normal range, it is necessary to trace the passage of LVDS signals from MainBoard EAX67133404 with an oscilloscope, as well as synchronizing signals to the loops with drivers.
Flooded or unsuccessfully washed screens of LED TVs can be restored, in about half of the cases, usually if significant damage has not formed in the loops and panel strips.
Owners of the 43UJ655V TV are advised to contact only qualified specialists with the necessary experience for repair! Attempts to repair yourself without the appropriate knowledge and skills can lead to irreversible negative consequences!
DOWNLOAD SCHEMATIC DIAGRAM / SERVICE MANUAL ------------------> CHASSIS : UD74P for models 43UJ67*V, 43UJ67*V-ZD, 43UJ67*V-ZC, 43UJ655V 43UJ655V-ZC, 43UJ701V 43UJ701V-ZC, 43UJ670V, 43UJ675V.
Additional MainBoard Repair:
The appearance of the MainBoard EAX67133404 is shown in the figure below:EAX67133404
External view of the power supply
Main features of the LG 43UJ655V device:
Installed matrix (LED panel) LC430DGG (FK) (M4) HC430DGN-ABSR2-211X.
Matrix control uses the HV430 Timing Controller (T-CON).
A converter combined with a power supply is used to power the backlight LEDs.
The formation of the necessary supply voltages for all nodes of the LG 43UJ655V TV is carried out by the EAX67267601 power module, or its analogs.
MainBoard - the main board (motherboard) is an EAX67133404 module, using Realtek K3Lp, FT24C256A, DTA2010M and others.
Tuner TDJN-G501D EBL61841001 provides reception of television programs and tuning to channels.
There are files to download for model 43UJ655V from the manufacturer:Files with updates and instructions:
File Description File Name Type Date Size
SW File (Version 05.80.50). Update instructions TV_Software_Update_Guide_v3.pdf PDF 01/22/2020 2014K
SW File (Version 05.80.50). Firmware (USB) Software_File (Version_05.80.50) .zip ZIP 01/22/2020 831673K
Compatible with 43UJ620V-ZA, 43UJ6307-ZA, 43UJ6309-ZA, 43UJ630V-ZA, 43UJ631V-ZA, 43UJ634V-ZD, 43UJ635V-ZF, 43UJ639V-ZE, 43UJ6517-ZA, 43UJ6519-ZA, 43UJ651V-ZA, 43UJ655V-ZC, 43UJ670V-ZD, 43UJ675V-ZC, 43UJ701V-ZC, 49UJ620V-ZA, 49UJ6307-ZA, 49UJ6309-ZA, 49UJ630V-ZA, 49UJ631V-ZA, 49UJ634V-ZD, 49UJ635V-ZF, 49UJ639V-ZE, 49UJ6517-ZA, 49UJ6519-ZA, 49UJ651V-ZA, 49UJ655V-ZC, 49UJ670V-ZD, 49UJ675V-ZC, 49UJ701V-ZC, 55UJ620V-ZA, 55UJ6307-ZA, 55UJ6309-ZA, 55UJ630V-ZA, 55UJ634V-ZD, 55UJ635V-ZF, 55UJ6517-ZA, 55UJ6519-ZA, 55UJ651V-ZA, 55UJ655V-ZC, 55UJ670V-ZD, 55UJ675V-ZC, 55UJ701V-ZC, 55UK6100PLA, 55UK6100PLB, 60UJ6307-ZA, 60UJ6309-ZA, 60UJ630V-ZA, 60UJ634V-ZD, 60UJ6517-ZA, 60UJ6519-ZA, 60UJ651V-ZA, 65UJ620V-ZA, 65UJ6307-ZA, 65UJ6309-ZA, 65UJ630V-ZA, 65UJ634V-ZD, 65UJ6517-ZA, 65UJ6519-ZA, 65UJ651V-ZA, 65UJ655V-ZC, 65UJ670V-ZD, 65UJ675V-ZC, 65UJ701V-ZC, 65UK6100PLA, 65UK6100PLB, 70UJ675V-ZA, 75UJ651V-ZB, 75UJ675V-ZA.
User Manuals and Instructions:
File type File name Language Date Size
User manual UJ655_ (RU) .pdf Russian 06/22/2017 16524K
Quick Start Guide w3.5_mr_e05_c.zip English, Estonian, Latvian, Lettish, Lithuanian, Russian 10/31/2019
Instructions for quick setup Web_OS_3.5_Smart_QSG_RUS.pdf Russian 13.09.2017 4888K
Files can be downloaded from the manufacturer's website for the 43UJ655V model.
LG 43UJ655V TV with LC430DGG-FKM4 LCD, 42.5 "(108 cm) 16: 9 format diagonal. The LCD panel implements the principle of direct display backlighting with rear-mounted LEDs - Direct LED.
The LC430DGG-FKM4 sensor and MainBoard EAX67133404 software are capable of realizing the highest UHD image quality at 3840x2160 resolution in 4K UHD, HDR. Image processing is performed using modern High Dynamic Range (HDR) technology with an extended range of brightness gradations.
TV model 43UJ655V has built-in SMART software and webOS operating system installed. The connection to the network can be carried out via Wi-Fi wireless connection. Supported media file formats: MP3, WMA, MPEG4, HEVC (H.265), DivX, MKV, JPEG.
Speaker sound system power 20 W (2x10 W) is provided by two speakers. The NICAM stereo audio processing system and the Sound Surround function are used.
Communication with other devices via an external interface is supported by standard input and output connectors: antenna input (RF), AV, component, HDMI x4, USB x2, Ethernet (RJ-45), Bluetooth, Wi-Fi 802.11ac, WiDi, Miracast.
The digital tuner can receive TV channels in the DVB-T MPEG4, DVB-C, DVB-T2, DVB-S2 standards.
The TV uses an EAX67267601 power supply.
Dimensions: with stand 974x630x235 mm, without stand 974x571x79 mm.
TV weight: with stand: 10.5 kg, without stand: 9.2 kg.
Attention! Panel LC430DGG-FKM4 LED-TV LG 43UJ655V is an expensive and unreliable element.
Do not allow any impact on the glass and pressure on the screen surface to avoid damage to the LED panel!
It is also unsafe for liquid to spill onto the screen. Sometimes one drop is enough if it drips down the glass onto the cables to make the TV unrepairable.
